|
User Manual for Arecont Vision MicroDome G2 Series 3MP Network Dome Camera Click to enlarge the picture
Contents of the user manual for the Arecont Vision MicroDome G2 Series 3MP
- Product category: Wired IP Cameras Arecont Vision
- Brand: Arecont Vision
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Arecont Vision Wired IP Cameras
|
User manual for the Arecont Vision MicroDome G2 Series 3MP contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Arecont Vision product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Arecont Vision user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Arecont Vision product will considerably shorten its lifespan!
|
Product description The MicroDome G2 Series 3MP Network Dome Camera (Flush Mount) from Arecont Vision features a 1/3" CMOS sensor for capturing videos at a maximum resolution of 2048 x 1536. This day/night camera provides 24-hour surveillance thanks to the mechanical IR cut filter. The IP camera comes in an in-ceiling housing, making it suitable for indoor applications.Enclosed in an IK10-rated vandal-resistant, cast-aluminum housing with a polycarbonate bubble, the camera is capable of withstanding force up to 55 lb. The IP camera delivers surveillance for a variety of network surveillance requirements. The remote focus module allows users to select “Short-range Focus” or “Full-range Focus” to save installation time.3-axis lens adjustment allows the camera to be mounted on a wall or ceiling for panning, tilting, and rotation of the lens in a variety of directions for a precise field of view. Incorporating a spring arm design, the camera can be installed by sliding it through the hole and securing the magnetized cover ring with a single screw. No additional hardware is required. The camera is ONVIF Profile S and PSIA (Physical Security Interoperability Alliance) compliant, thereby providing interoperability between network video products regardless of manufacturer. - True day / night functionality with mechanical IR cut filter
- CorridorView allows 90° image rotation for better coverage in hallways and corridors
- Privacy Masking, Motion Detection, Flexible Cropping, Bit Rate Control, Multi-Streaming, and Forensic Zooming
- Easily adjustable 3-axis gimbal
- All-in-one H.264 total PoE solution
- Ultra low-profile design and small size
- IK-10 impact-resistant housing for withstanding force up to 50 lb
In the Box Arecont Vision MicroDome G2 Series 3MP Network Dome Camera (No Lens,Flush Mount) Ceiling Template 4-Position I/O Connector Flat-Head Screwdriver Philips Head Screwdriver Limited 3-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Arecont Vision MicroDome G2 Series 3MP Network Dome Camera in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersArecont Vision AV3555 Specs | | | Image Sensor | 3 MP CMOS | | Sensor Size | 1/3" | | Pixel Pitch | 2.2 μm | | Minimum Illumination | Color (Day Mode): 0.2 lux
Color Binning (Day Mode): 0.1 lux
B/W (Night Mode): 0.02 Lux, IR sensitive | | Resolution | Full FOV (H x V): 2048 x 1536
1/4: 1024 x 768 | | Dynamic Range | 69.5 dB | | Frame Rates | At Max Resolution: 21 fps (2048 x 1536)
Cropped: 30 fps (1920 x 1080), 41 fps (1280 x 1024)
Binning Mode: 46 fps (1024 x 768), 64 fps (960 x 540) | | | | Optics | Remote focus module | | Low Light Capability | Pixel Binning mode | | Picture-in-Picture | Simultaneous delivery of full field-of-view and zoomed images | | Shutter Speed | Programmable: Controls motion blur, 1 to 500 ms | | Motion Detection | Real-time, 1024 detection zones | | Privacy Masking | Unlimited | | Cropping | Flexible: Resolution windowing down to 1 x 1 pixel for JPEG and 2 x 2 pixels for H.264 | | Backlight Compensation | Custom white balance | | Flicker Filter Control | 50/60 Hz selectable | | Image Rotation | CorridorView (90°, 180°, and 270° image rotation) | | Noise Reduction | Low light noise filter control | | Microphone | Integrated | | Efficiency | Bit rate and bandwidth limitation control
Bandwidth and storage saving by running at 1/4 resolution | | Sharpness | Selectable enhancement level | | Miscellaneous | Programmable resolution, brightness, saturation, gamma, tint, electronic PTZ (pan, tilt, zoom) | | | | Compression | G.711 PCM, 8 kHz | | Input | Microphone in | | | | Compression Type | H.264 (MPEG-4, part 10) / Motion JPEG
21 levels of quality | | Network Protocols | RTSP, RTP/TCP, RTP/UDP, HTTP, DHCP, TFTP, QoS, IPv4, IPv6 | | Network Interface | 100Base-T Ethernet | | Multi-Streaming | 8 non-identical streams | | | | Industry Standards | ONVIF Profile S and PSIA conformant | | Listings | UL (CB) | | FCC Compliance | 47 CFR 15 Class A | | Environmental | RoHS, REACH, WEEE | | Agency and Regulatory Marks | (CE) EN55022 Class A, EN55024, EN61000-3-2, EN61000-3-3, EN60950-1 | | Vandal Resistance | IK-10 | | Ingress Protection | IP66 | | Country of Origin | Made in the USA | | | | Operating Temperature | 23 to 122°F (-5 to 50°C) | | Humidity | 0 to 90% (non-condensing) | | Storage Temperature | -4 to 140°F (-20 to 60°C) | | | | Alarm Input / Output | General purpose opto-coupled, 1 input /1 output | | PoE | PoE 802.3af, Class 3 | | Power Consumption | 5.59 W (DC power) | | | | Casing | Tamper-resistant housing, IK-10 impact-resistant in-ceiling mount with die-cast aluminum cover and 2" polycarbonate dome bubble | | Gimbal | 3-axis camera adjustment with 359° pan, 90° tilt, and 360° z-axis | | Dimensions (Ø x H) | 4 x 3.1" (10 x 7.9 cm) | | Weight | 0.7 lb ( 0.3 kg) |
Rating90% users recommend this product to others. And what about you?
This product has already been rated by 06 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
inspiron 3470...
Film Scanner 8 mm + super 8 REELS MOVIE MAKER PRO...
HP 3630 deskjet printer/scanner...
Dell KB216 ITALIAN Slim Office Multimedia Keyboard BLACK.
...
Mistral MC2300R 25L Detachable Air Coller with Steriliser.
Thank you in advance for your assistance.
Sincerely,
Jonathan Chua...
|
| Discussion |
Latest contributions to the discussion:
Provident aut voluptas.
Name: Ophelia Crist
Logitech Wireless Presenter R400
this product is perplexed....
Feedback regarding your services
Name: Jessica Parisian
Logitech Wireless Presenter R400
I tried to cremate it but got Turkish Delight all over it....
Instructions for assembling the 2015 Forecast Image Master Consoles GC3-A
Name: mike elam
Forecast Consoles GC3-A ImageMaster Editing Console
Looking for instructions for assembling this console. ...
EMPTY TONER ERROR MESSAGE AFTER REPLACING TONER
Name: LINDA BAD YELLOW EYES
Brother TN223BK Standard-Yield Toner
I HAD TO CHANGE OUT ALL THREE TONERS DUE TO LEAKS IN THE YELLOW AND CYAN. AFTER I REPLACED THEM, THE MACHINE KEEPS GIVING ME AN EMPTY TONER ERROR MESSAGE. HELP!!...
PS480D 20/24 pin Switching 480W Power Supply
Name: swkargo
Logisys 480W Power Supply
This item states in can run -5vdc .It is NOT listed on the board or I beleive is r4 is missing the resitior. Any body have thid issue. Shawn
...
|
|
