|
User Manual for ART SLA-2-F 2-Channel Studio Linear Power Amplifier Click to enlarge the picture
Contents of the user manual for the ART SLA-2-F 2-Channel Studio Linear Power
- Product category: Power Amplifiers ART
- Brand: ART
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for ART Power Amplifiers
|
User manual for the ART SLA-2-F 2-Channel Studio Linear Power contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any ART product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official ART user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a ART product will considerably shorten its lifespan!
|
Product description The SLA-2-F from ART is a rack mountable two-channel power amplifier designed for studio use. It offers a wide frequency response with very low noise and distortion for quality audio output. XLR, 1/4", and Euroblock input connectors are provided, along with five-way binding post outputs. Each channel has its own level control on the front panel.
The SLA-2-F can operate in stereo or bridged mode, and features a ground-lift switch to eliminate hum caused by ground loops. The unit offers full protection circuitry for short circuits, overloads, and overheating. If any faults are detected, the amplifier will disconnect the outputs and automatically return to normal operation when the fault is fixed. The SmartFan cooling system offers silent fan-assisted convection cooling to keep the system running reliably. - High quality audio with low distortion
- Individual level controls for each channel
- XLR, 1/4", and Euroblock inputs, 5-way binding post outputs
- Stereo or bridged operating modes
- Ground-lift switch for eliminating hum
- LED indicators for power, signal, clip, and protect
- SmartFan cooling system is fan-assisted for quiet, reliable operation
- Protection circuitry prevents damage from overheating, overloads, and short circuits. It will disconnect the outputs when a fault is present, and resume normal operation when the fault has been removed
UPC: 840402021506 In the Box ART SLA-2-F 2-Channel Studio Linear Power Amplifier (230V) Power Cord 3-Year Limited Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the ART SLA-2-F 2-Channel Studio Linear Power Amplifier in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersART SLA2-CE Specs | Output Power | 200W RMS Per Channel @ 8 Ohms Stereo
280W RMS Per Channel @ 4 Ohms Stereo
560W RMS @ 8 Ohms Bridged-Mono | | Damping Factor | > 100 | | Input Sensitivity | 1V for Full Power into 8 Ohms | | Input Impedance | 44 kOhms, Balanced
22 kOhms, Unbalanced | | Gain | Not Specified by Manufacturer | | Frequency Response | 10Hz - 40kHz, ±0.5dB | | Signal-to-Noise Ratio | Not Specified by Manufacturer | | Total Harmonic Distortion (THD) | < 0.05% (Typical) | | Input Connectors | 2 x XLR Female
2 x 1/4" Jacks
1 x 6-Pin Removable Terminal Block
1 x AC Power In | | Output Connectors | 4 x 5-Way Binding Posts (2 Per Channel) | | Controls Front Panel | 1 x Power Switch
2 x Level Control Knobs | | Controls (Rear) | 1 x Stereo/Bridge Mode Selector Switch
1 x Ground-Lift Switch | | Indicators | 1 x Blue Power LED
2 x Red Protect LEDs
2 x Red Clip LEDs
2 x Green Signal LEDs | | Cooling | SmartFan Convection Cooling, Silent Fan-Assisted System | | Power | 230VAC | | Dimensions (WxHxD) | 19 x 1.75 x 13.5" (483 x 44 x 343mm) | | Weight | 19.8 lbs (9kg) | | | | Package Weight | 23.0 lb | | Box Dimensions (LxWxH) | 24.0 x 18.0 x 5.0" |
Rating80% users recommend this product to others. And what about you?
This product has already been rated by 65 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
NEWER F100 CAMERA MONITOR...
PhotoStage progessional...
powerpint...
Night Detective Quest 5M 5x Night Vision Monocular ...
Ibanez AM93QM User Manual....
|
| Discussion |
Latest contributions to the discussion:
TR-P5TP pink robot dog
Name: Allyson
Top Race Race & Remote Control
Hello we are having issues with the remote to the robot dog it just flashes a red light will not sync to the robot dog what so ever the dog is charged and batteries have been changed out more the once, Can i get help trouble shooting the issue or if something needs to be sent bac...
Query
Name: Libba Guyton
Canon Pixma TS9520 Wireless All-In-One Printer
Support Code 1851
Multi purpose tray guide is open. Close the guide and press OK.
Done and the same message continue to appear....
Manual
Name: Grant
Konus KonuStart-700B 60mm f 11.6 Refractor
Please send user manual for Konustart-700B to above email address....
Fs3x manual
Name: Randy Reid
DigiTech FS3X Three-Function Foot Switch
I need manual
...
adding additional chime
Name: Stan Stansfield
OhmKat Video Doorbell Power Supply for
The additional chime does not work and is closure to the transmitter then the first one. I plugged in the additional chime and set the volume and chime. The original chime works when the additional chime is plugged in to new location. The original chime is located further away bu...
|
|
