|
User Manual for Astatic 930VPL Continuously Variable Pattern Surface Mounted Boundary Microphone Click to enlarge the picture
Contents of the user manual for the Astatic 930VPL Continuously Variable Pattern Surface
- Product category: Boundary Microphones Astatic
- Brand: Astatic
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Astatic Boundary Microphones
|
User manual for the Astatic 930VPL Continuously Variable Pattern Surface contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Astatic product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Astatic user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Astatic product will considerably shorten its lifespan!
|
Product description The 930VPL Surface Mounted Boundary Microphone from Astatic is an ideal solution for speech and signal capturing on podiums, desktops, pulpits, etc. The condenser microphone features a flat, low-profile profile with two mounting holes located at the base. The continuously variable polar pattern control features cardioid, omnidirectional and figure eight patterns with variations between them.A momentary membrane switch may be programmed for push-to-talk, push-to-mute and on/off operation. With its high gain before feedback and surface noise rejection, the 930VPW is an ideal surface microphone for boardrooms, classrooms, court proceedings, conferences and houses-of-worship. This boundary microphone features a TA4M output connector and comes with a TA4F to 3-pin XLR cable. - Continuously Variable Polar Pattern
- The continuously variable polar pattern control features cardioid, omnidirectional, and figure eight patterns with variations between them.
- Logic Control I/O
- The Logic input and output enables remote control over the membrane switch and LED.
- Programmable Membrane Switch
- A momentary membrane switch may be programmed for push-to-talk, push-to-mute and on/off operation.
- 12 dB High Pass Filter Switch
- A 12 dB high pass filter eliminates rumble, ambiance and proximity noise.
- Surface Noise Rejection
- The 930VPW rejects surface audio reflection which eliminates phasing and additional noise issues.
- Windscreen and Steel Grille
- A protective grille features a wind screen underneath for wind, plosives and sibilance control.
- XLR Connection
- An attached cable features an XLR connector for use with standard microphone preamplifier inputs.
UPC: 631922103670 In the Box Astatic 930VPL Continuously Variable Pattern Surface Mounted Boundary Microphone 30' TA4F to 3-Pin XLR Cable Protective Pouch Adhesive Security Cover Limited 2-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Astatic 930VPL Continuously Variable Pattern Surface Mounted Boundary Microphone in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersAstatic Boundary AS930VPL Specs | | | Transducer | Condenser | | Polar Pattern | Cardioid, Figure-8, Omnidirectional | | Pattern Selection | Continuously Variable | | Frequency Range | 90 Hz to 17 kHz | | Equivalent Noise Level | 24 dB A-Weighted | | Maximum SPL | 120 dB SPL | | THD | 1% | | Impedance | 120 Ohms | | Sensitivity | 25 mV/Pa | | Low-Cut Filter | 12 dB/Octave @ 80 Hz | | | | Output Connectors | 1 x TA4M | | Operating Current Consumption | 4 mA | | Operating Voltage | 12 V
24 V
48 V | | Length | 5.51" / 140 mm | | Weight | 8 oz / 227 g | | | | Package Weight | 1.325 lb | | Box Dimensions (LxWxH) | 14.0 x 9.45 x 3.1" |
Rating90% users recommend this product to others. And what about you?
This product has already been rated by 31 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Manual for HP ThinC T530 Mini GX-215JJ Linux Mint...
Kingwin Super Speed 3.0 S/N KW11805020007...
Logitech MK850 Manual...
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
|
| Discussion |
Latest contributions to the discussion:
Line 6 Amplifi
Name: David Nicoll
Line 6 AMPLIFi FX100 Multi-Effects Guitar
I have a line 6 Amplifi 100 and my problem is when i press switches ABCD to bank up and down nothing happens i have downloaded all up dates but still can not bank up down
Regards
David Nicoll ...
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
|
|
