|
User Manual for Comtek BST-25 216 Synthesized Base Station Transmitter with Rackmount Click to enlarge the picture
Contents of the user manual for the Comtek BST-25 216 Synthesized Base Station
- Product category: Base Stations Comtek
- Brand: Comtek
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Comtek Base Stations
|
User manual for the Comtek BST-25 216 Synthesized Base Station contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Comtek product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Comtek user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Comtek product will considerably shorten its lifespan!
|
Product description The 1RU BST-25/216 Synthesized Base Station Transmitter from Comtek is an auxiliary base station transmitter which comes with a 1RU rack-mounting faceplate. The base station transmitter is designed to operate in the 216-217 MHz band under parts 22, 74 and 90 of the FCC regulations making it compatible with other manufacturers' all-in-ear type receivers operating in this band. For highest fidelity operation, the PR-216 receiver must be used with the wide-band companded channels. An external antenna (not included) can be attached through a BNC RF connector. This transmitter may be used for personal cueing, tour guide applications, language interpretation, and assistive listening. The BST-25/216 also operates with the Phonak microEar VHF in-ear receiver in the narrow-band non-companded channels. The BST-25/216 transmitter incorporates digital and analog technologies to produce low residual noise, wide dynamic range, and extended frequency response rendering the most natural sound possible from a wireless system. - 60 user-selectable channels in the 216 to 217MHz range: 40 standard narrow-band, non-companded channels; 20 high-fidelity narrow-band channels with companded audio processing
- Single window, bright LED display for exact frequency and channel, VU bar graph meter, antenna condition and lock-out indicator
- Test tone generator for receiver testing and audio level referencing
- Balanced mic or line level with 60 dB of control range to accommodate any audio level
- Micro controller automatically sets the modulation deviation, audio mode for processing, and the EQ when corresponding channels are selected
- It can be rackmounted, and can accommodate a variety of remote antennas
In the Box Comtek BST-25/216 Synthesized Base Station Transmitter with Rackmount (1 RU) RMK-25-216 Rack-Mounting Faceplate (1RU) 4 x Rack Screws Limited 2-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Comtek BST-25 216 Synthesized Base Station Transmitter with Rackmount in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersComtek BST 25-216 RMK Specs | Audio Inputs | Mic XLR, 600 Ohms balanced -40 dBV (nominal)
Line XLR, 10 Ohms balanced 0 dBV (nominal) | | Connectors | XLR-3 female audio input connector for mic and line input
XLR-4 male power input 12 V
BNC type RF output connector | | Indicators | LED bar graph VU meter displays audio input (modulation)
Two-digit alpha numeric display shows operating channel
Five-digit numeric display shows operating frequency
Antenna indicator displays deficient antenna condition
Lock out indicator shows tuning has been disabled | | Antenna | BNC RF output connector for optional external antenna | | FCC Compliance | Type accepted under Parts 22, 74, and 90 | | Power Requirements | 12 VDC, 300 mA max | | Freq. Response (Rec/Repro) | 80 Hz - 10 kHz | | Audio Distortion | Less than 1% at 80% modulation | | Modulation | Soft compressor type with high (25 dB) linear overload protection, attack time less than 1 ms, recovery time 10 ms | | Gain Control | Greater than 40 dB | | Generators | Test Tone: 400 Hz 0.05% distortion | | Modulation | Frequency: 5 and 10 kHz deviation | | RF Output Power | Set for 100 mW | | Frequency Stability | Better than 20 ppm, digitally synthesized, crystal controlled | | Operating Frequency | 216-217 MHz | | Harmonic & Spurious Emissions | Better than 55 dB below carrier | | Dimensions | 6.5 x 1.8 x 5.6" (165.1 x 45.7 x 142.4 mm) | | Weight | 2.8 lb (1.2 kg) | | | | Package Weight | 3.845 lb | | Box Dimensions (LxWxH) | 20.1 x 8.6 x 4.05" |
Rating60% users recommend this product to others. And what about you?
This product has already been rated by 49 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Expert intel sixcore i5-8400 4GHZ turbo...
Color LaserJet Pro MFP M281fdw...
call of duty world war II...
Audio Technica AUDIO-AT8631
data sheet ...
Sunpak Ultra 7000TM 2-1 tripod/monopod...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
Redfield 2-7x33
Name: Mike
Redfield 2-7x33 Revolution Riflescope
Can the elevation and windage knobs be reset to zero?
Thanks!...
|
|
