|
User Manual for Golden Age Project Pre-573 MKII 500 Series Microphone Preamplifier Click to enlarge the picture
Contents of the user manual for the Golden Age Project Pre-573 MKII 500
- Product category: Microphone Preamps Golden Age Project
- Brand: Golden Age Project
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Golden Age Project Microphone Preamps
|
User manual for the Golden Age Project Pre-573 MKII 500 contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Golden Age Project product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Golden Age Project user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Golden Age Project product will considerably shorten its lifespan!
|
Product description Featuring a soft-start circuit that increases power draw and a lower-noise performance from its predecessor, the Pre-573 MKII 500 Series Microphone Preamplifier from Golden Age Project is based on the classic 1073 mic preamp design, and offers up to 80 dB of gain for its mic and instrument inputs, while a fully balanced line-input pad allows you to connect line-level sources. Its output gain control allows you to hit its input harder without resulting in peaking output levels, resulting in transformer and circuit saturation for warm or distorted tones. A dedicated insert connector in the back of the module allows you to connect it to other GAP 500 series processing units, which require a mic pre for use. - Soft start circuit that slowly increases the current draw
- Revised power supply with lower noise compared to the MKI
- Increased AIR boost to 6 dB
- Fully balanced line input pad
- Vintage Style electronics based on the 1073 mic pre. No integrated circuits in the signal path
- The output is transformer balanced and fully floating and can drive a 600 ohm load up to level of about 28 dBu
- Maximum gain on the mic input is 80 dB, enough to handle passive ribbon mics with quiet sound sources
- The total gain range goes from -15 to +80 dB. The 10 - 70 dB range is handled by a turn switch and a toggle switch selects an additional 5 or 10 dB gain
- Switchable impedance on the mic input, 1200 or 300 ohms, will change the tone of many mics
- The input can be configured to accept line level signals by another switch, the level is then lowered by about 25 dB and the input impedance increased to about 15 kohm
- Switchable phantom power with a LED indicator
- A front panel instrument input for any sound module, electric guitar or bass that can be selected between a high impedance Active or a mid-Z Passive mode. These two DI-options makes it possible to get different tones from electric instrument. The Passive DI input mode is usually more suited for injecting active units like sound modules
- The output level control makes it possible to make fine gain adjustments and also to overload the main gain stage and then lower the signal to a suitable level before the output stage
- Insert jack for inserting Golden Age Project 500 Series effect units. The insert can be activated by removing a jumper at the back of the module
- Selectable AIR equalizer adds a small boost above 10 kHz.
- A signal and overload indicator is offered by a single LED that starts glowing red at about +4 dBu and then increases its intensity up to the maximum output level
- Tantalum capacitors in the signal path
- Selectable 600 ohm Output Termination at the back of the module
- Circuit board star grounding scheme
Table of Contents
|
Upload User Manual
Have you got an user manual for the Golden Age Project Pre-573 MKII 500 Series Microphone Preamplifier in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersGolden Age Project PRE573MK2 Specs | Maximum Gain | Mic Input: 80 dB
Total Gain Range: -15 to +80 dB | | Input Impedance | Mic Input: Switchable between 300 and 1200 ohms
Line Input: 15 kOhms | | EQ Section | Selectable AIR switch adds 6 dB boost above 10 kHz | | Output Impedance | Selectable 600 ohm output termination | | | | Package Weight | 3.1 lb | | Box Dimensions (LxWxH) | 9.9 x 8.3 x 3.5" |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 34 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Manual for HP ThinC T530 Mini GX-215JJ Linux Mint...
Kingwin Super Speed 3.0 S/N KW11805020007...
Logitech MK850 Manual...
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
|
| Discussion |
Latest contributions to the discussion:
Line 6 Amplifi
Name: David Nicoll
Line 6 AMPLIFi FX100 Multi-Effects Guitar
I have a line 6 Amplifi 100 and my problem is when i press switches ABCD to bank up and down nothing happens i have downloaded all up dates but still can not bank up down
Regards
David Nicoll ...
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
|
|
