|
User Manual for Jensen Transformers Iso-Max DIN-LOD 1-Channel Line Output Isolator Click to enlarge the picture
Contents of the user manual for the Jensen Transformers Iso-Max DIN-LOD 1-Channel Line
- Product category: Modules & Cards Jensen Transformers
- Brand: Jensen Transformers
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Jensen Transformers Modules & Cards
 |
User manual for the Jensen Transformers Iso-Max DIN-LOD 1-Channel Line contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Jensen Transformers product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Jensen Transformers user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Jensen Transformers product will considerably shorten its lifespan!
|
Product description Ideal for use in performance venues, broadcast houses, and broad-scale A/V installations, the Jensen Transformers Iso-Max DIN-LOD is a passive, single-channel line output isolator designed to drive balanced and unbalanced audio signals over long distances, while eliminating hum caused by ground loops. The unit is plug-and-play with no power required, and snaps into place onto a standard 35mm DIN rail, for easy installation in a NEMA electrical enclosure.The DIN-LOD features a high-performance Jensen transformer with internal Faraday shield that isolates the input from the output to reduce common-mode noise by as much as 110 dB. Furthermore, a choice of connection point options allows you to optimize the grounding circuitry to suit your specific installation needs. The unit is capable of withstanding input levels in excess of +22 dB at 20 Hz, without discernible distortion. It delivers an extra-high output level of +22 dBu with a flat frequency response from 2 Hz to 100 kHz.Connections to and from the Iso-Max DIN-LOD are made via removable screw-down wire terminals. The module comes equipped with a gray molded assembly made from UL94-VO flame-retardant Noryl. - Key Features
-
- Passive, single-channel line output isolator for broadcast, A/V, and performance venue installations
- Drives balanced and unbalanced signals over long distances
- Extra-high output at + 22 dBu
- Provides galvanic isolation between input and output to eliminate hum caused by ground loops
- Rejects noise by as much as 110 dB
- Snaps into place onto a standard 35mm DIN rail for easy installation in a NEMA electrical enclosure
- Jensen high-performance transformer
- Flat frequency response from 2 Hz to 100 kHz
- Handles signals in excess of +22 dB at 20 Hz without discernible distortion, with almost zero insertion loss
- Choice of connection point options allows you to optimize grounding scheme to suit your installation
- Connections to and from the module are made via removable screw-down wire terminals
- Made from gray molded assembly made from UL94-VO flame retardant Noryl
- Plug-and-play, easy to use, no power required
UPC: 676101041763 In the Box Jensen Transformers Iso-Max DIN-LOD 1-Channel Line Output Isolator (Extra-High Output, DIN Rail) Limited 1-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Jensen Transformers Iso-Max DIN-LOD 1-Channel Line Output Isolator in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersJensen Transformers DIN-LOD Specs | Type | Passive, line output isolator | | Channels | 1 | | Format | For standard 35 mm DIN rail in National Electrical Manufacturers Association (NEMA) electrical enclosure | | Connectors | Removable, screw-down wire terminals | | Frequency Response | 2 Hz to 100 kHz | | Input Impedance | 20 Hz to 20 kHz, 0 dBu, test circuit 3
Minimum: 670 Ohms
Typical: 680 Ohms
Maximum: 690 Ohms | | Voltage Gain | 1 kHz, 0 dBu, test circuit 1, Rs = 0 Ohm
Minimum: -1.2 dB
Typical: -1.1 dB
Maximum: -0.9 dB | | Magnitude Response | 20 Hz, 0 dBu, test circuit 1, ref 1 kHz, Rs = 0 Ohm
Minimum: -0.10 dB
Typical: -0.02 dB
Maximum: ± 0.00 dB
20 kHz, 0 dBu, test circuit 1, ref 1 kHz, Rs = 0 Ohm
Minimum: -0.10 dB
Typical: ± 0.00 dB
Maximum: +0.10 dB | | Deviation from Linear Phase | 20 Hz to 20 kHz, 0 dBu, test circuit 1, Rs = 0 Ohm
Typical: +0.3 / -0°
Maximum: ± 1.0° | | Bandwidth | LF -3 dB re 1 kHz, test circuit 1, Rs = 0 Ohm
Typical: 0.10 Hz
HF -3 dB re 1 kHz, test circuit 1, Rs = 0 Ohm
Typical: 15 MHz | | Distortion (THD) | 1 kHz, +4 dBu, test circuit 1, Rs = 0 Ohm
Typical: < 0.001%
20 Hz, +4 dBu, test circuit 1, Rs = 0 Ohm
Typical: 0.004%
Maximum: 0.03% | | Maximum Output Level | At 20 Hz, 1% THD, test circuit 1, Rs = 0 Ohm
Minimum: +20 dBu
Typical: +22 dBu | | Common Mode Rejection Ratio | 60 Hz, test circuit 2
Typical: 110 dB
3 kHz, test circuit 2
Minimum: 75 dB
Typical: 85 dB | | Output Impedance | 20 Hz to 20 kHz, 0 dBu, test circuit 4
Typical: 80 Ohms | | Turn Ratio | Minimum: 0.999:1
Typical: 1.000:1
Maximum: 1.001:1 | | Optimal Cable Length | Input
Typical: 164' / 50 m
Maximum: 656' / 200 m
Output
No limitations | | Temperature Range | 32 to 158°F / 0 to 70°C (operation or storage) | | Voltage Difference | Winding to Winding
Minimum: 250 V RMS (60 Hz, 1 minute test duration)
Winding to Frame
Minimum: 500 V RMS (60 Hz, 1 minute test duration) | | Construction | Gray, molded assembly made from UL94-VO flame-retardant Noryl | | Dimension (L x W x H) | 3.85 x 2.06 x 2.3" / 97.8 x 52.3 x 58.4 mm | | | | Package Weight | 1.02 lb | | Box Dimensions (LxWxH) | 4.7 x 3.4 x 3.4" |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 04 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Logitech MK850 Manual...
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
Color LaserJet Pro MFP M281fdw...
call of duty world war II...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
Redfield 2-7x33
Name: Mike
Redfield 2-7x33 Revolution Riflescope
Can the elevation and windage knobs be reset to zero?
Thanks!...
|
|
