|
User Manual for Pelco DD436 Spectra IV SE Dome Drive Click to enlarge the picture
Contents of the user manual for the Pelco DD436 Spectra IV SE Dome
- Product category: Interface Modules Pelco
- Brand: Pelco
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Pelco Interface Modules
|
User manual for the Pelco DD436 Spectra IV SE Dome contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Pelco product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Pelco user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Pelco product will considerably shorten its lifespan!
|
Product description The Pelco DD436 Spectra IV SE Dome Drive in the Spectra IV SE Series Dome System helps produce high quality video in the most difficult environments. All cameras in Spectra IV SE dome drives feature LowLight technology allowing the cameras to compensate for scenes where minimal light is present. Both the 36x cameras feature built-in motion detection and advanced 128x WDR that enables the system to compensate for scenes where dramatic contrasts in lighting are present. The 36x day/night camera electronic image stabilization digitally reduces blurring of the camera image due to vibration caused by external sources, such as wind and traffic. Auto sharpness enhances picture detail by increasing the aperture gain of the camera and sharpening the edges in the picture. - Electronic image stabilization
- Multilingual menus (English, Spanish, Portuguese, Italian, French, German, Russian, Polish, Turkish, and Czech)
- RJ-45 data port for software update & setup
- On-screen compass, tilt, & zoom display
- 400°/sec pan preset speed and 200°/sec tilt preset speed
- Rotating discreet liner with sealed fixed bubble
- Window blanking: Up to 8, four-sided, user-defined shapes
- 8 Zones (configurable in size) can be labeled with up to 20 characters each or set to output blank video
- 1 Auxiliary (Form C) relay output and 1 open collector auxiliary output (can be alternately configured to operate upon alarm)
- Configurable locations of labels and on-screen displays
- Action on Alarm: Alarms can be individually configured for 3 priority levels, to initiate a stored pattern, or to go to an associated preset when received
- Resume After Alarm: Allows the dome to return to a previously configured state after alarm acknowledgement or to its previous position before alarm
- Multiple park & power-up action
- Patterns: Up to 8, on-screen, user-defined configurable patterns; includes Pan, Tilt, Zoom, & Preset functions
- Proportional Pan/Tilt: Continually decreases pan/tilt speeds in proportion to depth of zoom
- Variable Scan Speed: Scan speed can be configurable between 1 to 40°/sec
- Pan Motion allows 0.1 to 150°/sec pan speed
- Configurable limit stops for auto/random/frame scan modes
- Autosensing Protocol (Coaxitron, RS-422 Pelco P and Pelco D, Sensormatic, Vicon)
- Digital position and zoom control and feedback through Pelco D Protocol
- Built-in menu system for setup of configurable functions
- "Auto Flip" rotates dome 180° at bottom of tilt travel
- Low lux noise reduction (reduces noise in low light)
UPC: 700880317655 In the Box Pelco DD436 Spectra IV SE Dome Drive (NTSC) Limited 3-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Pelco DD436 Spectra IV SE Dome Drive in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersPelco DD436 Specs | | | Signal Format | NTSC | | Scanning System | 2:1 interlace / 1:1 progressive scan (user selectable) | | Image Sensor | 1/4" EXview HAD | | Effective Pixels (H x V) | 768 x 494 | | Horizontal Resolution | >540 TVL | | Lens | f/1.4 (focal length, 3.3 to 119 mm) | | Zoom | 36x optical, 12x digital | | Zoom Speed | Optical range: 3.2/4.6/6.6 seconds | | Angle of View | Horizontal: 57.2° at 3.3 mm wide zoom; 1.7° at 119 mm telephoto zoom | | Focus | Automatic with manual override | | Sensitivity | Maximum at 35 IRE
0.55 lux at 1/60 sec (color)
0.018 lux at 1/2 sec (color)
0.00018 lux at 1/2 sec (B&W) | | Sync System | Internal/AC line lock, phase adjustable using remote control, V-Sync | | White Balance | Automatic with manual override | | Shutter Speed | Automatic (electronic iris) / Manual 1/2 to 1/30,000 | | Iris Control | Automatic iris control with manual override | | Gain Control | Automatic / Off | | Video Output | 1 Vpp, 75Ω | | Video Signal | To Noise >50 dB | | Wide Dynamic Range | 128x | | | | Pan Movement | 360° continuous pan rotation | | Vertical Tilt | Unobstructed 2 to -92° | | Manual Pan/Tilt Speeds | Pan: 0.1 to 80°/sec manual operation,
150°/sec Turbo
Tilt: 0.1 to 40°/sec manual operation | | Preset Speeds | Pan: 400°/sec
Tilt 200°/sec
For variable-speed operation, an appropriate controller is required (with nonvariable speed control, Spectra IV SE pan/tilt speed is 20°/sec) | | | | Input Voltage | 18 to 32 VAC; 24 VAC nominal
22 to 27 VDC; 24 VDC nominal | | Input Power | 24 VAC
23 VA nominal (without heater);
73 VA nominal (with heater)
24 VDC
0.7 A nominal (without heater);
3 A nominal (with heater) | | Fuse | 1.25 A | | Auxiliary Output | 2 | | Auxiliary Input | 7 | | | | Package Weight | 4.2 lb | | Box Dimensions (LxWxH) | 10.315 x 9.764 x 9.685" |
Rating70% users recommend this product to others. And what about you?
This product has already been rated by 18 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
I need a user manual and parts diagram for a Manfrotto Super Salon 280 Camera Stand - 9’
Thanks!...
OBIHI phone model number obi1032...
Instructions manual for a SONY woofer Model number: SA-W10...
I need the manual for a printer Brother MFC-J805DW. Reason is cause my printer is not recognizing the generic color cartridges LC3035...
I have a question, can you contact me at valenti-lanza@m.spheremail.net ? Cheers!...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Bruce Dunn
Avid Sibelius | Ultimate Standalone Perpetual
I seem to have lost the lower right hand icon that allows me to input notes, rests, voices etc. Can you tell me how to get it back?...
Difficult to remove the gooseneck mic. Help or advice needed.
Name: Joe Matos
Telex MCP90-18 - Panel Mount Gooseneck
Hi, I picked up an RTS KP-32 intercom and it has a gooseneck MCP90 mic installed, however I can't get it to come off. I read that it is reverse threaded 1/ 4" TRS, however when I tried by gripping it hard and turning clockwise, it still didn't come off. And turning counterc...
Question
Name: Dean Williams
Moultrie ATV Food Plot Spreader -
When spreading seed, does the gate automatically close when you turn the spreader off? Or do you have to close the gate via some other action?...
Video Promotion for your website?
Name: Joanna Riggs
Salamander Designs Keyboard Storage Shelf for
Hi,
I just visited search-manual.com and wondered if you'd ever thought about having an engaging video to explain or promote what you do?
Our prices start from just $195 USD.
Let me know if you're interested in seeing samples of our previous work.
Regards,
Joanna...
Need a REPAIR manual
Name: Dennis Behrends
Loctek Flexispot V9 Desk Exercise Bike
How do I get a REPAIR manual for a Loctek Flexispot V9 Desk Exercise Bike. I cannot get the petal crank off so I can remove the side panel. I have a crank removal tool but I'm afraid it will strip the threads because it is really stuck on there....
|
|
