|
User Manual for Pelco DSSRV2-080-US Digital Sentry H.264 Network Video Recorder Click to enlarge the picture
Contents of the user manual for the Pelco DSSRV2-080-US Digital Sentry H.264 Network
- Product category: Network Video Recorders (NVRs) Pelco
- Brand: Pelco
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Pelco Network Video Recorders (NVRs)
|
User manual for the Pelco DSSRV2-080-US Digital Sentry H.264 Network contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Pelco product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Pelco user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Pelco product will considerably shorten its lifespan!
|
Product description The 8 TB DSSRV2-080-US Digital Sentry H.264 Network Video Recorder from Pelco is optimized to deliver essential hardware support for the DS NVs video management software (VMS) without the risk of integrating hardware and software. Boosted by the 4th Generation Intel Xeon processor and 16GB of RAM, the Digital Sentry NVR provides an optimal combination of processing power and reliability to meet the demands of HD video recording and playback operations. The system is powered to support up to 128 combined IP and analog video streams, with up to 64 analog cameras supported via the optional ENC5416 directly attachable encoder (sold separately). Analog streams are also supported using Pelco and third-party encoders. The NVR delivers total available throughput of 350 Mb/s for recording of analog and IP video streams as well as playback and export through the DS ControlPoint client. When determining the maximum number of cameras and the desired frame rate to host on every system, the number of concurrent client connections, the number of streams likely to be viewed in playback on each client, and the bandwidth required to support the client connections must be taken into consideration. The NVR functions as a standalone system or as part of a network of servers, monitored from the DS ControlPoint user interface. The system can be deployed solely as a network video recorder, as a digital video recorder (DVR), or as a hybrid NVR. Thanks to the 2 gigabit network ports, handy network architecture planning is facilitated by allowing 1 port to be dedicated to IP cameras, while the second network port is used for client connections. 2 DVI-D ports provide a convenient connection for high-resolution digital monitors for use with HD cameras. The NVR incorporates a SSD system drive. With increased read-write speeds and no moving parts, the SSD system drive increases the reliability, uptime, and responsiveness of the system. The 8 TB SSD drive is hot-swappable when configured for internal RAID 5 storage with the optional RAID 5 controller card (sold separately). External storage is supported through USB attached storage or by using the DSSRV-SCSI interface card (sold separately) connected to DX8100HDDI storage of up to 24TB. The external storage can be configured for JBOD storage of software-controlled RAID 5 storage. The unit comes with a US power cord.Front panel LED displays on the recorder provide heads-up information on system operation. The LEDs are integrated with the new Digital Sentry System Information (DSSI) utility, providing critical, real-time statistics on system resource utilization, temperature, and throughput status. - Digital Sentry Network Video Recorder with a 8 TB internal SSD
- Unit can be rackmounted and requires 2 RU of space
- 350 Mb/s to support IP and analog video
- Supports up to 128 IP camera streams; up to 64 analog cameras
- Optimized to support pre-installed DS NVs software
- Records H.264, MJPEG, and MPEG-4 IP streams
- Supports Pelco and third-party IP cameras and network encoders
- Expandable by networking an unlimited number of servers and encoders (dependent on available network bandwidth
- Compatible with DS ControlPoint for simultaneous monitoring of all DS series and DX series products in a single client interface
- Network health and event monitoring support through simple network management protocol (SNMP) and new Digital Sentry System Information (DSSI) utility
- Compatible with the DS archive utility
- Recording rate configurable per individual camera
- Support for DS DataPoint integration
- Comes with a US power cord
- Fully Open Architecture is provided through ONVIF compliance and support for a large number of IP specific drivers
In the Box Pelco DSSRV2-080-US Digital Sentry H.264 Network Video Recorder (8 TB, US Power Cord) DSSWCAM Additional IP Camera License USA Power Cord (3 Prong) 6' (1.8m) Molded Connector USB Keyboard Mouse 2 x Bezel Key Rackmount Kit for Mounting in a 2 RU Rack Limited 3-Year Warranty Guides & Manuals Table of Contents
|
Upload User Manual
Have you got an user manual for the Pelco DSSRV2-080-US Digital Sentry H.264 Network Video Recorder in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Download User ManualThe user manual for the Pelco DSSRV2-080-US Digital Sentry H.264 Network Video Recorder can be downloaded in PDF format at the link stated below.
Technical parametersPelco DSSRV2 Specs | Supported Standards | NTSC/PAL | Processor | Intel Xeon E3-1275 v3 | Operating System | Windows 7 Ultimate 64-bit SP1 | Internal Memory | 16 GB DDR ECC RAM | User Interface | DS ControlPoint | Internal Storage | JBOD or RAID 5: 8 TB The minimum configuration for an internal RAID 5 is 3 hard disk drives. A hard disk drive of the RAID 5 configuration is used for parity, reducing net storage capacity by 1 hard disk drive | RAID Level | Internal RAID 5 (requires DS-SRV-RAID controller card for hot-swappable drives) DSSRV-RAID controller sold separately. The internal RAID 5 requires re-imaging from a bootable 8 GB USB key (sold separately). | External Storage | Pelco's DX8100HDDI or third-party SCSI targets (requires optional DSSRV-SCSI) Card sold separately. | System Drive | SSD | Storage | 6 x 3.5" hard drive bays | Optical Drive | DVD±RW | USB Ports | 3 x USB 2.0 ports (1 x front, 2 x rear), 2 x USB 3.0 ports (rear) | | Video System | Intel HD Graphics P4700 (shared memory) | Maximum Resolution | 3840 x 2160 per DisplayPort output (2x) 1920 x 1200 @ 60 Hz on DVI-D output 1920 x 1200 @ 60 Hz on VGA output | Video Outputs | Supports up to 3 simultaneous displays using any combination of the four outputs | Video Standards | 60 Hz capable for NTSC | Decoding | MPEG-4 ASP; H.264 Baseline, Main, and High profiles | Performance | 16x real-time MPEG-4 streams at 704 x 480 12x real-time H.264 Baseline profile streams at 704 x 480 4x H.264 Baseline profile streams at 720p 2x real-time H.264 Baseline profile streams at 1080p | | Audio Decoding | G.711 speech codec | Bit-Rate | 64 kb/s | Audio Level | Input: Electret microphone Output: Up to 3 Vp-p, adjustable, minimum load of 8 Ohms | Audio Connectors | 2 x 3.5 mm stereo jacks | Tips | Signal left (input and output) | Ring | Signal right (input and output) | Audio Inputs | Microphone | Audio Outputs | Speaker or line out | | Interface | 2 Gigabit Ethernet RJ45 (1000Base-T) | | Buttons | Power | Indicators | Unit Status: Green, amber, red Primary Network: Green, amber, red Secondary Network: Green, amber, red Software Status: Green, amber, red (based on diagnostics) Hard Disk Status: Green, red, off (behind bezel) | | Power Input | 100 to 240 VAC, 50/60 Hz, auto-ranging | Power Supply | Internal | Power Consumption | Operating Maximum: 100 VAC / 50 Hz: 222.0 W, 2.22 A, 758.0 BTU/h 110 VAC / 50 Hz: 224.0 W, 2.02 A, 759.4 BTU/h 110 VAC / 60 Hz: 223.0 W, 2.03 A, 761.4 BTU/h 115 VAC / 50 Hz: 217.0 W, 1.89 A, 740.8 BTU/h 115 VAC / 60 Hz: 215.5 W, 1.87 A, 735.7 BTU/h 220 VAC / 50 Hz: 213.0 W, 0.97 A, 727.2 BTU/h 220 VAC / 60 Hz: 204.1 W, 0.93 A, 696.8 BTU/h 240 VAC / 50 Hz: 211.9 W, 0.88 A, 723.4 BTU/h 240 VAC / 60 Hz: 207.6 W, 0.86 A, 708.8 BTU/h | | Operating Temperature | 50 to 95°F (10 to 35°C) | Storage Temperature | -40° to 149°F (-40 to 65°C) | Operating Humidity | 20 to 80%, non-condensing | Maximum Humidity Gradient | 10% per hour | Operating Altitude | -50 to 10,000' (-15 to 3,048 m) | Operating Vibration | 0.25 g at 3 to 200 Hz at a rate of 0.5 octave/minute | Certifications | CE, Class A; meets EN50130-4 standard requirements FCC, Class A UL/cUL Listed C-Tick CCC KCC S-Mark | | Dimensions (DxWxH) | 20 x 17.1 x 3.5" (50.8 x 43.4 x 8.9 cm) | Weight | 36 lb (16.3 kg) | | Package Weight | 49.0 lb | Box Dimensions (LxWxH) | 27.1 x 24.1 x 11.1" |
Rating70% users recommend this product to others. And what about you?
This product has already been rated by 08 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Go Pro FETCH Dog Harness ADOGM-001... Trijacon ACOG USMC scope... Pyle Pro BTA 62BT 6-Zone Stereo Receiver Bluetooth... LG Gram 17 Laptop... LG 300W 2.1 ch surround sound manual. It has the soundbar, subwoofer, wireless receiver for connected rear speakers and wireless controller. ...
|
Discussion |
Latest contributions to the discussion:
lithium ion battery pack EN-EL5 3.7 V 1100mAh Name: Jane Holland Nikon EN-EL5 Lithium-Ion Battery HI:
How can I tell if this (old) battery is still good? I cannot charge it on my old Nikon COOLPIX P500 camera.
Thank You
Jane Holland
... lithium ion battery pack EN-EL5 3.7 V 1100mAh Name: Jane Holland Nikon EN-EL5 Lithium-Ion Battery HI:
How can I tell if this (old) battery is still good? I cannot charge it on my old Nikon COOLPIX P500 camera.
Thank You
Jane Holland... Settings access and setup Name: Edwin Derks Nuance PaperPort 14 I had a problem with Paperport loading. Through the remote efforts of a Tech was able to get back online, however, "settings" are only listed 1 - 5 with no action listed as was 'visibly' available, (i.e. Scan both sides, Black and White, Color, etc.)
1. how to change, 2. wha... query Name: Vudayagiri Balasubramanyam Bose Wave SoundTouch Music System IV how to set up my bose radio with my remote working-class ... Hi. I didn’t even get a chance to try it once! :( plz help Name: Eric Tasakovic Keeley Dark Side Pedal I ordered a dark side pedal second hand online for 20 bucks cheaper than it would have been to buy it new….20 measly bucks. Anyway…it didn’t come with a power supply. I messed up and accidentally plugged in a 9v ac output power supply in, instead of the required 9v dc. I’...
|
|