|
User Manual for Pelco FSV10D1S1ST Single-Channel Digitally Encoded Video with Bidirectional Data Fiber Transmission System Click to enlarge the picture
Contents of the user manual for the Pelco FSV10D1S1ST Single-Channel Digitally Encoded Video
- Product category: Signal Extenders Pelco
- Brand: Pelco
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Pelco Signal Extenders
|
User manual for the Pelco FSV10D1S1ST Single-Channel Digitally Encoded Video contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Pelco product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Pelco user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Pelco product will considerably shorten its lifespan!
|
Product description The FSV10D1S1ST Single-Channel Digitally Encoded Video with Bidirectional Data Fiber Transmission System from Pelco transmitter allows transmission of one unidirectional composite video channel and one bidirectional RS-422 data channel over one optical fiber when used with its associated receiver. The FSV10D1 transmitter allows the user to choose bidirectional data or up-the-coax through use of a dip switch on the compatible FRV10D1 receiver unit. The selection of RS-422 data communication allows PTZ control of the Spectra IV dome. With Coaxitron control, PTZ control signals are transmitted over video coaxial cable from the controller to the FRV10D1 receiver. The receiver then transmits the Coaxitron data onto the fiber to the FSV10D1 transmitter. This Coaxitron data is transmitted from the controller to the Spectra IV dome during the vertical blanking interval of the video signal. The FSV10D1 transmitter includes a corresponding 13" fiber cable for easier pre-wiring installation and it operates using power supplied from the Spectra IV dome. - Designed for use in Spectra IV domes
- 10-bit digitally encoded video for high-quality video transmission over a single fiber
- Bidirectional RS-422 data channel or Coaxitron communication
- Supports Pelco Coaxitron up-the-coax control signals for a distance up to 43 miles
- Single-mode fiber support for distances up to 37 miles
- Exceeds all requirements of the RS-250C medium-haul transmission specification
- Laser diode for transmission of optical signals
- Compatible with NTSC, PAL, and SECAM video standards
- Designed to meet NEMA TS-1/TS-2 and Caltrans traffic signal control equipment environmental standards
- LED status indicators for monitoring all critical operating parameters
UPC: 700880297728 In the Box Pelco FSV10D1S1ST Single-Channel Digitally Encoded Video with Bidirectional Data Fiber Transmission System (Single Mode, ST Connector) 13" Cable Limited 1-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Pelco FSV10D1S1ST Single-Channel Digitally Encoded Video with Bidirectional Data Fiber Transmission System in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersPelco FSV10D1S1ST Specs | | | Input | 1 Vpp, 75 ohms | | Overload | >1.5 Vpp | | Bandwidth | 5 Hz to 6.5 MHz | | Differential Gain | <2% | | Differential Phase | <0.7° | | Tilt | <1% | | Signal-to-Noise Ratio | 67 dB at maximum optical loss budget | | Coaxial Cable Capability | 300' (100 m) cable to connect camera to fiber optic module to maintain 6 MHZ bandwidth | | | | Interface | RS-422 | | Rate | DC to 115 kbps (NRZ) | | | | Connector | ST | | Wavelength | 1310/1550 nm; single mode | | Number of Fibers | 1 | | Optical Power Budget | 20 dB | | Transmission Distance | 37 miles (60 km) | | Optical Emitter | Laser diode | | LED Indicators | Link | | Power | 8 to 15 VDC at 350 mA from dome | | | | Certifications | CE, Class A; FCC, Class A; UL/cUL listed; C-Tick; designed to meet NEMA TS 1/TS 2 and Caltrans traffic signal control equipment environmental standards | | MTBF | >100,000 hours | | Operating Temperature | -40 to 167°F (-40 to 75°C) | | Storage Temperature | -40 to 185°F (-40° to 85°C) | | Relative Humidity | 0 to 95%, non-condensing | | Dimensions | 4.0 × 2.5" (10.2 × 6.4 cm) | | Weight | 0.46 lb (0.21 kg) | | | | Package Weight | 0.45 lb | | Box Dimensions (LxWxH) | 10.787 x 6.457 x 3.15" |
Rating90% users recommend this product to others. And what about you?
This product has already been rated by 23 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Manual for HP ThinC T530 Mini GX-215JJ Linux Mint...
Kingwin Super Speed 3.0 S/N KW11805020007...
Logitech MK850 Manual...
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
|
| Discussion |
Latest contributions to the discussion:
Line 6 Amplifi
Name: David Nicoll
Line 6 AMPLIFi FX100 Multi-Effects Guitar
I have a line 6 Amplifi 100 and my problem is when i press switches ABCD to bank up and down nothing happens i have downloaded all up dates but still can not bank up down
Regards
David Nicoll ...
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
|
|
