|
User Manual for Pelco POE4ATN 4-Port Gigabit High PoE IEEE802.3at Midspan with US Power Cord Click to enlarge the picture
Contents of the user manual for the Pelco POE4ATN 4-Port Gigabit High PoE
- Product category: Power over Ethernet (PoE) Pelco
- Brand: Pelco
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Pelco Power over Ethernet (PoE)
|
User manual for the Pelco POE4ATN 4-Port Gigabit High PoE contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Pelco product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Pelco user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Pelco product will considerably shorten its lifespan!
|
Product description The Pelco POE4ATN 4-Port Gigabit High PoE IEEE802.3at Midspan is designed to meet the demanding data rate and power requirements of IP cameras with high-quality streaming video capabilities. The midspan offers total output power of 33.6W per port, and meets the IEEE802.3at standard for detection, connection, disconnection, and fault protection. It also provides SNMP network management. The POE4ATN Midspan is compatible with 10/100/1000Base-T systems and has an input voltage range of 90 to 264 VAC. - Fully 802.3at compliant detection with disconnect, over voltage / current / temperature protection
- 10/100/1000Base-T compatibility
- No power management required
- Web interface through network management port
- 75 percent efficiency at maximum load and 120 VAC, 60 Hz
UPC: 700880327388 In the Box Pelco POE4ATN 4-Port Gigabit High PoE IEEE802.3at Midspan with US Power Cord US Power Cord Limited 1-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Pelco POE4ATN 4-Port Gigabit High PoE IEEE802.3at Midspan with US Power Cord in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersPelco POE4ATN-US Specs | | | Voltage Rating | Input: 90 to 264 VAC | | AC Input Current (Rated) | 2.5 A (RMS) maximum for 90 VAC
1.3 A (RMS) maximum for 240 VAC | | Leakage Current | 3.5 mA maximum at 254 VAC, 60 Hz | | AC Input Frequency | 47 to 63 Hz | | AC Inrush Current | 30 A (RMS) maximum for 115 VAC
60 A (RMS) maximum for 230 VAC | | Total Output Power | 33.6 W per port | | Ripple | Ripple & Regulation: 100 mV maximum | | Efficiency | 75% (typical) at maximum load; 120 VAC, 60 Hz | | Hold-Up Time | 10 ms minimum; 120 VAC and maximum load | | Voltage Protection Rating | Transient O/P Voltage Protection: 60 V maximum at switch on and off at any AC line phase | | Turn-On Time from Auto Power Down | 3 sec maximum at maximum load and 120 VAC, 60 Hz | | Isolation | Primary to Secondary: 4,242 VDC for 1 minute
Primary to Ground: 2,121 VDC for 1 minute
Secondary to Ground: 2,121 VDC for 1 minute | | Protection | Over Voltage/Current Short Circuit: Outputs equipped with short circuit protection and overload protection according to IEEE802.3at specification; the output can be shorted permanently without damage | | NIC Support | For remote management by secure IP access | | Input Connector | AC: IEC320 inlet 3-pin (C14) | | | | Temperature | Operating: 32 to 104°F (0 to 40°C)
Storage: -4 to 149°F (-25 to 65°C)
Over Temperature Protection: Automatic shutdown without damage | | Maximum Humidity Gradient | 5 to 90% | | Immunity | Immunity EN50082-1
ESD: EN61000-4-2, level 3
RS: EN61000-4-3, level 2
EFT: EN61000-4-4, level 2
Surge: EN61000-4-5, level 3
CS: EN61000-4-6, level 2
Voltage Dips: EN61000-4-11
Harmonic: EN61000-3-2 class A | | Certifications | CE, EN55022 class B
FCC, part 15, class B
UL/cUL listed | | Dimensions (WxHxD) | 7.87 x 1.93 x 8.86" (200 x 19.3 x 225 mm) | | | | Package Weight | 4.65 lb | | Box Dimensions (LxWxH) | 11.2 x 10.5 x 3.0" |
Rating90% users recommend this product to others. And what about you?
This product has already been rated by 53 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Jumpdrive C20i...
Pacsafe Travel Safe 200...
Narink Pro Food chopper B871 users manual...
manual for: "Battery Charger CG-580"...
Dawnstar Electric Knife Sharpener Model: S858-2 user ...
|
|
