|
User Manual for Powerwerks PW150TFXBT 150 Watt PA Tower with Digital Effects and Bluetooth Click to enlarge the picture
Contents of the user manual for the Powerwerks PW150TFXBT 150 Watt PA Tower
- Product category: Portable PA Systems Powerwerks
- Brand: Powerwerks
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Powerwerks Portable PA Systems
|
User manual for the Powerwerks PW150TFXBT 150 Watt PA Tower contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Powerwerks product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Powerwerks user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Powerwerks product will considerably shorten its lifespan!
|
Product description 7 All-In-One Portable Speaker Systems for Special Events and Parties Read More The PowerWerks PW150TFXBT 150 Watt PA Tower with Digital Effects and Bluetooth is a portable system designed for a variety of situations such as amplifying vocals, instruments, keyboards, drum machines, audio devices, and more. The built in Bluetooth 3.0 + EDR compliant receiver supports the A2DP profile which enables higher quality streaming from your Bluetooth enabled computer or mobile device.
The speaker uses four 4.5" speakers and a high frequency driver to provide defined mid frequencies and clear highs with a full range frequency response of 60 to 20,000 Hz. A dedicated active crossover with a 1/4" mono plug subwoofer jack adjusts the response to 150 to 20,000 Hz so you can incorporate a dedicated subwoofer. A separate monitor output with dedicated level control allows you to further expand the system. The unit's POWERLINK circuit allows you to connect multiple units together using standard XLR microphone cables, each with an independent master level control.
The back panel of the speaker features a three channel mixer with two simultaneous 1/4" instrument and XLR-3F mic channels, each with high and low eq controls. It also feature an 1/8" mini input for pre-recorded music with a high and low eq control. The sound of your music can be further adjusted using the four built-in DSP effects: room reverb, hall reverb, chorus + reverb, and delay + reverb. The construction of the speaker includes a heavy-duty steel grill and rigid corners. It can be positioned on a standard speaker stand. - Bluetooth Receiver
- Enables Bluetooth 3.0 + EDR compliant streaming with support for the A2DP profile
- DSP Effects
- Offers room reverb, hall reverb, chorus + reverb, and delay + reverb
- POWERLINK Circuit
- Allows you to connect multiple units together
- Subwoofer Output With Active Crossover
- Enables incorporating a dedicated subwoofer into your system
In the Box Powerwerks PW150TFXBT 150 Watt PA Tower with Digital Effects and Bluetooth Power Cord Limited 3-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the Powerwerks PW150TFXBT 150 Watt PA Tower with Digital Effects and Bluetooth in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersPowerwerks PW150TFXBT Specs | Bluetooth | Version 3.0 + EDR compliant
Typical +2 dBm class 2 output power
Audio DAC: 94 dB SNR | | A2DP | Yes | | Inputs | CH1: balanced XLR-3F, unbalanced 1/4" line level
CH2: balanced XLR-3F, unbalanced 1/4" line level
CH3: 1/8" line level | | Output Power | At 1%: 2x 75 W (4 Ohms load) | | Drivers | 4x 4.5" at 50 W 8 Ohm load
Horn: 3.5" piezo driver | | Frequency Response | Input: 20 to 20,000 Hz
Full Range Speaker: 60 to 20,000 Hz
Subwoofer Crossover Active: 150 to 20,000 Hz | | Nominal Impedance | 2x 4 Ohms | | Power Capacity | 150 W RMS | | Hum and Noise | Residual (all levels at 0%): -46 dB
Nominal system at 40% level controls: -37 dB | | System Gain | Mic to Speaker Output (CH1 and CH2): +49 dB
Line to Speaker Output (CH1 and CH2): +35 dB
Aux in to Speaker Output: +25 dB | | Channel EQ | High: 4,000 Hz and above
Low: 800 Hz and below | | Link | POWERLINK: balanced input on XLR-3F to balanced XLR-3M output | | Subwoofer Output | Line Out: 20 to 150 Hz | | Monitor Out | Line Out: balanced TRS output with grounded sleeve | | Phantom Power | Mic inputs (CH1 and CH2): +15 V | | Power Requirements | USA/Canada: 120 VAC 60 Hz, 300 W nominal
Europe: 230 VAC 50 Hz, 300 W nominal
UK: 230 VAC 50 Hz, 300 W nominal
Australia: 240 VAC 50 Hz, 300 W nominal
Japan: 100 VAC 50-60 Hz, 300 W nominal | | Dimensions (W x H x D) | 7.5 x 28.0 x 6.5" (190 x 715 x 165 mm) | | Weight | 25.0 lb (11.3 kg) |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 74 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
Color LaserJet Pro MFP M281fdw...
call of duty world war II...
Audio Technica AUDIO-AT8631
data sheet ...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
Redfield 2-7x33
Name: Mike
Redfield 2-7x33 Revolution Riflescope
Can the elevation and windage knobs be reset to zero?
Thanks!...
|
|
