|
User Manual for Quested 3-Way 10" Mid-Field Main System Powered Reference Monitor Click to enlarge the picture
Contents of the user manual for the Quested 3-Way 10" Mid-Field Main System
- Product category: Studio Monitors Quested
- Brand: Quested
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Quested Studio Monitors
|
User manual for the Quested 3-Way 10" Mid-Field Main System contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Quested product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Quested user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Quested product will considerably shorten its lifespan!
|
Product description The V3110 3-Way 10" Mid-Field / Main System Powered Reference Monitor is Quested's highest-rated self powered monitoring system. The combination of Class A/B and D amplifiers provides the V3110 with 1000 watts of continuous RMS tri-amped power. The monitor utilizes a 3-way speaker design with low frequency response down to 30 Hz from its custom designed, linear-travel, long throw 10" driver. The high frequency tweeter and mid range speakers are designed with Quested's low-fatigue soft-dome technology, and are capable of adjusting for either horizontal or vertical positioning. A 24 dB / Octave crossover slope delivers improved drive unit efficiency. The speaker monitor features user adjustable low, mid and high frequency filters. LEDs are provided to indicate power on/off, overload and thermal protection status. The V3110 was engineered to deliver a versatile, high power density in a reference monitor cabinet with a minimal footprint and size. - Quested's highest-rated self-powered monitoring system
- 3-way design with low frequency response down to 30 Hz from linear travel, long throw 10" driver
- 1000 Watt RMS from combination of Class A/B and Class D amplification
- Quested low-fatigue soft-dome high-frequency and mid-range technology
- Adjustable HF / Mid section to accommodate versatile horizontal or vertical positioning
- Current-driven, floating drive stage Class A/B power for HF and Mid drivers
- Dedicated 700 Watt RMS Class D amplifier for improved LF driver dynamics
- 24 dB/octave crossover slopes for improved drive unit efficiency
- Very high-power density for cabinet footprint and size
Table of Contents
|
Upload User Manual
Have you got an user manual for the Quested 3-Way 10" Mid-Field Main System Powered Reference Monitor in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersQuested V3110 Specs | Drivers | Low Frequency: 1 x 10" (25.40 cm) Mid Frequency: 1 x 3" (7.62 cm) High Frequency: 1 x 1.125" (2.86 cm) | Maximum SPL | 120 dB | Frequency Response | 30 Hz to 20 kHz, +/- 2 dB | Power Voltage | Factory set. Nominal 115 V or 230 V @ 50-60 Hz AC | | Connectors | XLR Female and 1/4" Jack combo | Impedance | 10 k ohm / Electronically balanced, RF filtered | Wiring | Pin 1: Ground / Sleeve Pin 2: Hot / Tip Pin 3: Cold / Ring | Sensitivity | Rear-mounted 10 position rotary switch Calibrated in 2 dB steps | | Low Frequency EQ | User, 4-position: -6 dB selector (for use with subwoofers) 0/+3/+4 dB | Mid Frequency EQ | User, 3-position selector: -1/0/+1 db | High Frequency EQ | User, 3-position selector: -1/0/+1 db | | Low Frequency Output | 700 watts RMS continuous | Mid Frequency Output | 150 watts RMS continuous | High Frequency Output | 150 watts RMS continuous | THD | >0.03% at levels up to 1 dB below clipping 20 Hz to 20 kHz Typical 0.005% at 20 watts/RMS @ 1 kHz | Hum & Noise | >-100 dB referred to clipping | | Power On Mode | Front blue LED indicates Power On Flashes during warm-up cycle | Overload | Front LED flashes red Indicating B below signal clipping | Thermal Protection | Front LED turns red, signal is muted Amplifier switches to Standby during thermal protection cooling cycle | | Dimensions (W x H x D) | 14.96 x 23.62 x 14.17" (380 x 600 x 360 mm) | Weight | 85.98 lb (39 kg) |
Rating70% users recommend this product to others. And what about you?
This product has already been rated by 41 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Honeywell Home Doorbell 916.8 MHz Product Ref: 3231665-002 Rev B... Go Pro FETCH Dog Harness ADOGM-001... Trijacon ACOG USMC scope... Pyle Pro BTA 62BT 6-Zone Stereo Receiver Bluetooth... LG Gram 17 Laptop...
|
Discussion |
Latest contributions to the discussion:
lithium ion battery pack EN-EL5 3.7 V 1100mAh Name: Jane Holland Nikon EN-EL5 Lithium-Ion Battery HI:
How can I tell if this (old) battery is still good? I cannot charge it on my old Nikon COOLPIX P500 camera.
Thank You
Jane Holland
... lithium ion battery pack EN-EL5 3.7 V 1100mAh Name: Jane Holland Nikon EN-EL5 Lithium-Ion Battery HI:
How can I tell if this (old) battery is still good? I cannot charge it on my old Nikon COOLPIX P500 camera.
Thank You
Jane Holland... Settings access and setup Name: Edwin Derks Nuance PaperPort 14 I had a problem with Paperport loading. Through the remote efforts of a Tech was able to get back online, however, "settings" are only listed 1 - 5 with no action listed as was 'visibly' available, (i.e. Scan both sides, Black and White, Color, etc.)
1. how to change, 2. wha... query Name: Vudayagiri Balasubramanyam Bose Wave SoundTouch Music System IV how to set up my bose radio with my remote working-class ... Hi. I didn’t even get a chance to try it once! :( plz help Name: Eric Tasakovic Keeley Dark Side Pedal I ordered a dark side pedal second hand online for 20 bucks cheaper than it would have been to buy it new….20 measly bucks. Anyway…it didn’t come with a power supply. I messed up and accidentally plugged in a 9v ac output power supply in, instead of the required 9v dc. I’...
|
|