|
User Manual for RDL FP-MR2 Message Repeater Click to enlarge the picture
Contents of the user manual for the RDL FP-MR2 Message Repeater
- Product category: Message Announcers & Alerts RDL
- Brand: RDL
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for RDL Message Announcers & Alerts
|
User manual for the RDL FP-MR2 Message Repeater contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any RDL product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official RDL user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a RDL product will considerably shorten its lifespan!
|
Product description The RDL FP-MR2 Message Repeater permits electronic storage of a single recording of up to a duration of 1 minute 40 seconds. This recorded message may be played back manually using an external contact closure to ground or using the front-panel start button. The message may also be played back periodically using the interval timer included in the FP-MR2 Message Repeater. A balanced line-level music input allows background music to be connected and the associated input potentiometer allows the installer to set the music level. When message playback is triggered, the music is faded down. At the conclusion of the message, the music level fades back up. A front-panel DIP switch sets the music to fade under the message (-20 dB nominal) or completely off (used for messages containing music). The module output level is a nominal +4 dBu balanced. The output level is indicated on an RDL dual-LED VU meter which is used to set the proper music and recording levels.
The message may be recorded once, at installation, and then played back repeatedly. The message may be re-recorded at any time and is retained when power is removed from the module. The recording input is a standard -10 dBV consumer level, unbalanced phono jack. An input level trimmer is provided to set the correct recording level which is indicated on the dual LED meter. The front-panel record enable push-button erases the message in memory and enables recording, indicated by the record enable LED. The module begins recording when the start button is pushed and continues until the button is released. The REC LED is illuminated during recording. An integral audio compressor maintains a consistent average recording level over 20 dB input of level variation without significant audible effect on the signal dynamics. - Music quality message recording
- Up to 1.7 minute digital message storage
- External message actuation
- Interval timer to repeat message playback
- Automatic voice-over or music ducking
UPC: 813721012715 In the Box RDL FP-MR2 Message Repeater Limited 3-Year Warranty Table of Contents
|
Upload User Manual
Have you got an user manual for the RDL FP-MR2 Message Repeater in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersRDL FP-MR2 Specs | | | Input | 10 kΩ unbalanced | | Input Level | -20 to 0 dBV | | Frequency Response | 80 Hz to 12 kHz (±1.5 dB) | | Noise | Below +4 dBu: < -65 dB | | | | Input | 50 kΩ balanced or unbalanced | | Input Level | For +4 dBu out: -18 dBu balanced (-20 dBV unbalanced) to +18 dBu balanced (+16 dBV unbalanced) | | Frequency Response | 30 Hz to 40 kHz (±1 dB) | | THD + N | < 0.05% (1 kHz) | | Noise | Below +4 dBu: < -70 dB (unity gain) | | CMRR | >70 dB (50 to 150 Hz) | | Output | 150 Ω balanced or 75 Ω unbalanced | | Output Level | +4 dBu nominal | | Control Input | 2 x TRIG and DISABLE, Pull to ground, 1 mA | | Control Output | 2 x PLAYING and EOM, Open-collector @ 25 mA | | Power Requirement | 24 VDC @ 60 mA, Ground-referenced | | Operating Environment | 32 to 131°F (0 to 55°C) | | Dimensions | 1.36 x 3.25 x 5.00" (3.46 x 8.26 x 12.70 cm) | | | | Package Weight | 0.85 lb | | Box Dimensions (LxWxH) | 7.2 x 5.1 x 2.4" |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 85 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
I need a user manual and parts diagram for a Manfrotto Super Salon 280 Camera Stand - 9’
Thanks!...
OBIHI phone model number obi1032...
Instructions manual for a SONY woofer Model number: SA-W10...
I need the manual for a printer Brother MFC-J805DW. Reason is cause my printer is not recognizing the generic color cartridges LC3035...
I have a question, can you contact me at valenti-lanza@m.spheremail.net ? Cheers!...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Bruce Dunn
Avid Sibelius | Ultimate Standalone Perpetual
I seem to have lost the lower right hand icon that allows me to input notes, rests, voices etc. Can you tell me how to get it back?...
Difficult to remove the gooseneck mic. Help or advice needed.
Name: Joe Matos
Telex MCP90-18 - Panel Mount Gooseneck
Hi, I picked up an RTS KP-32 intercom and it has a gooseneck MCP90 mic installed, however I can't get it to come off. I read that it is reverse threaded 1/ 4" TRS, however when I tried by gripping it hard and turning clockwise, it still didn't come off. And turning counterc...
Question
Name: Dean Williams
Moultrie ATV Food Plot Spreader -
When spreading seed, does the gate automatically close when you turn the spreader off? Or do you have to close the gate via some other action?...
Video Promotion for your website?
Name: Joanna Riggs
Salamander Designs Keyboard Storage Shelf for
Hi,
I just visited search-manual.com and wondered if you'd ever thought about having an engaging video to explain or promote what you do?
Our prices start from just $195 USD.
Let me know if you're interested in seeing samples of our previous work.
Regards,
Joanna...
Need a REPAIR manual
Name: Dennis Behrends
Loctek Flexispot V9 Desk Exercise Bike
How do I get a REPAIR manual for a Loctek Flexispot V9 Desk Exercise Bike. I cannot get the petal crank off so I can remove the side panel. I have a crank removal tool but I'm afraid it will strip the threads because it is really stuck on there....
|
|
