User Manual for Rob Papen RP-Distort - Distortion and Effects Plug-In Click to enlarge the picture
Contents of the user manual for the Rob Papen RP-Distort - Distortion and
- Product category: Virtual Processor Plug-Ins Rob Papen
- Brand: Rob Papen
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Rob Papen Virtual Processor Plug-Ins
|
User manual for the Rob Papen RP-Distort - Distortion and contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Rob Papen product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Rob Papen user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Rob Papen product will considerably shorten its lifespan!
|
Product description RP-Distort from Rob Papen is not just a distortion plug-in, but offers more sound processing by allowing combining the distortion section with an analog modeled filter, compressor and widener unit. The order of the units can be changed and also turned on or off.
Controls can be modulated using MIDI sources, or by one of the four LFOs that can sync to the host tempo. Twenty-two distortion types are offered, included a ring modulator and Lo-Fi processor. EQ and a noise-gate are also available inside the distortion section. - Presets
-
- Uses sound banks composed of 128 presets
- Preset handling with copy, paste, clear and compare functions
- "Quick Browser", "Recently Browsed" and "Favorite" functions
- All settings are stored inside each preset
- Presets are stored in clear categories banks
- ESC
-
- External controller hardware (fader-box) settings can be saved and restored
- Distortion
-
- Amplifier simulation - none, 4 x 10" guitar speakers, 4 x 12" guitar speakers, bass speaker, combo speaker, radio speaker
- Cabinet simulator with several cabinet types - none, Fender, Marshall, off axis
- Clipper limits output using a large range of preset settings
- Cosine
- Cross 1
- Cross 2
- Foldover amplifies and then 'folds over' the sound
- Fuzz-box
- Gapper distortion
- Hard-limiter
- Low-Fi reduces the sample and bit rate and adds noise to the signal
- OverDrive
- Octave 1
- Octave 2
- Power wave-shaping
- Rectify
- Ring Modulation
- Saturate
- SoftLimit
- Squarify turns the source to a square wave and low-pass filters it
- Transient distorts a sound's beginning
- Tube Simulator
- EQ
-
- 4-band equalizer effect inside distortion section
- 125 Hz, 1.5 kHz, 2.2 kHz and 8 kHz
- EQ on/off
- Noise Gate
-
- Noise gate (inside distortion section) silences any sound below a set threshold
- Threshold, attack, hold and release controls
- Gate on/off
- Filter
-
- Low- and high-pass filters, in that order
- 12 and 24 dB pole selection
- Adjustable frequencies
- Adjustable Q
- Compressor
-
- Threshold, ratio, attack, release and volume controls
- Compressor on/off
- Modulation
-
- Four free modulation routings with amount control
- Four LFOs with tempo based sync mode, waveform, speed, human feel, symmetry controls
- Bypass button for all active modulations
- Global amount control for all active modulations
Table of Contents
|
Upload User Manual
Have you got an user manual for the Rob Papen RP-Distort - Distortion and Effects Plug-In in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersRob Papen RP-Distort Specs | System Requirement | Mac
OS X 10.5 or higher
Host software that supports Audio Units (32- and 64-bit), RTAS (32-bit) and VST (32- and 64-bit) plug-in formats
Support for 32-bit Audio Units, RTAS and VST plug-ins under OSX 10.4 (Tiger)
PC
Windows XP, Vista, Windows 7
Host software that supports RTAS and VST plug-in formats (32- and 64-bit) Additional authorization for second computer/laptop available after registration of the original serial/license |
Rating90% users recommend this product to others. And what about you?
This product has already been rated by 66 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
