User Manual for Rob Papen RP-VERB 2 - Reverb Plug-In Click to enlarge the picture
Contents of the user manual for the Rob Papen RP-VERB 2 - Reverb
- Product category: Virtual Processor Plug-Ins Rob Papen
- Brand: Rob Papen
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Rob Papen Virtual Processor Plug-Ins
|
User manual for the Rob Papen RP-VERB 2 - Reverb contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Rob Papen product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Rob Papen user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Rob Papen product will considerably shorten its lifespan!
|
Product description The Rob Papen RP-VERB 2 plug-in produces dense and warm reverb sounds using ten reverb algorithms including Hall Clean, Hall Cave, Hall Warm, Room Cold, Room Edged, Room Storm, Vintage Type 1, Vintage Type 2, Space Orbit 1, and Space Orbit 2. It features a Reverser section, which allows you to reverse the reverb sound, sync it to the tempo of your host DAW, and create unique ambiences for vocals, loops, percussions, guitars, and more.The RP-VERB 2's Mod Matrix enables you to route three controllers such as Envelope Follower, Envelope, LFO, Offset, or MIDI, to three possible parameter destinations. This set up allows you to produce effects ranging from subtle to bold or even use the Envelope Follower module to easily recreate the Phil Collins gated-reverb effect.The Distortion module offers four types of distortion that let you add bite to your sound before hitting the reverb, ideal for boosting the presence of vocals or drums in your tracks. The plug-in ships with 500 presets to get you started right away.Also included is the Rob Papen RP-Delay plug-in. - Reverb
-
- RPCX algorithm reverb
- Models: Hall Clean, Hall Cave, Hall Warm, Room Cold, Room Edged, Room Storm, Vintage Type 1, Vintage Type 2, Space Orbit 1, Space Orbit 2
- Reverb size control
- Reverb length control
- Predelay with disorder control
- Tempo sync option for predelay
- Damping control
- Low-pass and hi-pass filters with on/off buttons
- Volume control
- On/off control
- Early Reflections
-
- Complex early reflection algorithm
- Routing into reverb or direct
- Length, damping, side-feedback, cross-feedback controls
- On/off control
- Late Reflections
-
- Late reflection delay
- Routing into reverb or direct
- Length control
- Tempo Sync option
- Damping control
- Volume control
- On/off control
- Reverser
-
- Reverses reverb signal
- Displays Length control
- Tempo Sync on/off
- Reverb-only control (everything is reversed in the Off state)
- Trigger level control
- Trigger offset control
- Re-trigger time control
- Reverse time control
- Attack control (reversed sound)
- Decay control (reversed sound)
- Mix control (between the reversed and normal output)
- On/off control
- General Controls
-
- Dry/wet control
- Wet-only button
- FX bypass button
- ECS (external MIDI controller setup)
- Question, ?, button displays user guide
- EQ
-
- High-quality EQ based on RP-EQ algorithm
- Post-audio routing option
- Low shelf at 80 Hz (20 dB)
- High shelf at 12 kHz (20 dB)
- Mid sweep with Q control and frequency range from 20 Hz to 20.5 kHz (20 dB)
- On/off control
- Distortion
-
- Types: Fold-over, Fuzz, Power, Saturation
- Amount 1 control
- Amount 2 control for sound adjustment
- On/off control
- Ensemble
-
- 6-voice chorus
- Amount control
- Routing into reverb or direct + reverb
- Volume control
- Speed control
- On/off control
- Envelope
-
- Controls RP-VERB 2 parameters
- Tempo sync option
- MIDI trigger option
- Host trigger option
- Trigger threshold
- Attack, hold, and release controls
- Loop function
- Two destinations with amount control
- On/off control
- Envelope Follower
-
- Special envelope for gated reverb effect
- Tempo sync option
- Mono input option
- Latch mode option
- Two additional free destinations with amount control
- On/off control
- LFO
-
- Controls RP-VERB 2 parameters
- Tempo Sync option
- Speed control
- Waveform control with phase
- MIDI trigger option
- Three possible destinations with amount control
- On/off control combined with Mod Matrix section
- Mod Matrix
-
- Three possible sources include envelope follower, envelope, LFO, offset, MIDI controllers
- Three possible destinations with amount control
- On/off control combined with LFO section
- Trigger
-
- Select trigger for Envelope or LFO
- Sources include host (music program start), note, pitch bend, mod wheel, breath controller, foot pedal, expression pedal, MIDI controllers (16 to 21, 84 to 90)
- Preset Section
-
- 500 presets
- Presets are stored as files in clearly categorized bank folders
- Quick Browser, Recently Browsed, and Favorite functions
In the Box Rob Papen RP-VERB 2 - Reverb Plug-In (Download) RP-Delay - Delay Plug-In Table of Contents
|
Upload User Manual
Have you got an user manual for the Rob Papen RP-VERB 2 - Reverb Plug-In in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersRob Papen RP-VERB 2 Specs | System Requirements | Mac OSX 10.6 or later (32- / 64-bit)Windows Vista, 7, 8, or 10Serial/license system with activation during product registration
A 2nd serial for a secondary computer/laptop is available after registering original serial/license. | | Plug-In Support | Mac: AU, VST, AAX
Windows: VST, AAX (Pro Tools 12 or later) |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 04 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
