User manual
Rode Stereo VideoMic Pro Rycote with

User Manual for Rode Stereo VideoMic Pro Rycote with Deadkitten Fur Windshield Kit

• Product category: Stereo & Specialty Microphones Rode
• Brand: Rode
• Description and content of package
• Technical information and basic settings
• Frequently asked questions – FAQ
• Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
• Authorized service for Rode Stereo & Specialty Microphones

Product description

• Rode Stereo VideoMic Pro Rycote
  • Introducing the new Stereo VideoMic Pro with Rycote Onboard
  The Stereo VideoMic Pro Rycote from Rode builds on the success of the Stereo VideoMic Pro with a few improved upgrades such as a Rycote Lyre shockmount, higher-sensitivity X/Y capsules, denser foam windscreen, better RF shielding, and a thicker Kevlar braided cable. The microphone retains all of the switch locations and other features as the previous model, for use as an on-camera DSLR and camcorder microphone for video applications. The integrated Rycote Lyre shockmount system protects against handling noise. The Stereo VideoMic features a high-pass filter switch at 75 Hz for minimizing low-frequency noise, and a -10 dB pad for maximizing headroom on behalf of capturing loud signals without distortion. The +20 dB level-boost switch is specifically designed to provide a higher-quality signal with DSLR cameras. When activated, the camera preamp level is reduced, resulting in a lower noise floor and a much clearer recording.
  • Broadcast-recording-quality on-camera microphone
  • Matched pair, 1/2" condenser capsules in X/Y stereo configuration
  • Ultra-lightweight, compact form factor
  • Two-step high-pass filter (flat, 75 Hz)
  • Three-position level control (-10, 0, +20 dB)
  • 9V-battery-powered - over 100 hours of use (alkaline)
  • Integrated Rycote Lyre shockmount
  • Denser foam windscreen
  • 1/8" (3.5mm) stereo mini-jack output
  • Billeted metal camera shoe mount with 3/8" thread for easy boompole mounting
  UPC: 698813004805
• Rode Dead Kitten Artificial Fur Wind Shield
  • Introducing the new Stereo VideoMic Pro with Rycote Onboard
  The RODE Dead Kitten Artificial Fur Wind Shield is designed for use with the RODE Stereo VideoMic, RODE Stereo VideoMic Pro, RODE Stereo VideoMic Pro Rycote, RODE WS4, and RODE NT4 microphone. It's specially designed with artificial fur that minimizes wind noise, while also remaining acoustically transparent. The Dead Kitten is actually the exact wind shield included with the Stereo VideoMic and is designed to suppress noise caused by high wind while outdoors.
  • The Dead Kitten wind shield is designed for minimizing any wind noise when using a microphone in high-wind conditions
  • The artificial fur is specially designed to minimize wind noise while also remaining acoustically transparent
  • Compatible with the RODE NT4, RODE WS4, RODE Stereo VideoMic, and RODE Stereo VideoMic Pro
  UPC: 698813000982

• Stereo VideoMic Pro Rycote yrwybzaxwxurtdxzceuasseefaufbxbsxv
• Metal Camera Shoe Mount with 3/8" Thread
• Foam Windscreen
• Limited 10-Year Extended Warranty with Registration

• Dead Kitten Artificial Fur Wind Shield

Upload User Manual

Please enter here the link to the user manual of this product: OR Enter here the file with the user manual of this product from your computer/phone: (60MB max; Permitted formats: PDF) 0%

Technical parameters

• Rode Stereo VideoMic Pro Rycote

  Transducer	Pressure gradient
  Polar Pattern	XY Cardioid
  Frequency Range	40 Hz to 20 kHz (selectable HPF @ 75 Hz)
  Sensitivity	-38 dB (12.6 mV @ 94 dB SPL) ±2 dB re 1 V/Pa @ 1 kHz
  Output Impedance	200 Ohms
  Maximum Output	+4.2 dBu (@ 1% THD into 1 kOhms)
  Dynamic Range	100 dB
  Maximum SPL	134 dB, max (1 kHz, 1% THD into 1 kOhms load)
  Signal / Noise	76 dBA (A-weighted per IED651)
  Power Supply	9 V alkaline battery
  Connection	1/8" (3.5 mm) stereo mini-jack
  Signal to Noise Ratio	76 dBA SPL (A-weighted per IEC651)
  Dimensions (D x W x H)	4.5 x 3.1 x 5.3" (115 x 80 x 134 mm)
  Weight	0.26 lb (116 g) (without battery)

  Box Dimensions (LxWxH)	8.5 x 5.1 x 3.2"

• Rode Dead Kitten Artificial Fur Wind Shield

  Material	Faux Fur
  Outer Diameter	3.2" / 8 cm
  Length	3.2" / 8 cm
  Weight	0.9 oz / 25 g

  Box Dimensions (LxWxH)	4.5 x 4.2 x 0.5"

Rating

Discussion