|
User Manual for Tascam SS-CDR250N Two-Channel Networking CD and Media Recorder Click to enlarge the picture
Contents of the user manual for the Tascam SS-CDR250N Two-Channel Networking CD and
- Product category: Digital Recorders & Players Tascam
- Brand: Tascam
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for Tascam Digital Recorders & Players
|
User manual for the Tascam SS-CDR250N Two-Channel Networking CD and contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any Tascam product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official Tascam user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a Tascam product will considerably shorten its lifespan!
|
Product description The SS-CDR250N Two-Channel Networking CD and Media Recorder from Tascam is a solid-state recorder that features networking and can accept an optional IF-DA2 Dante card for integrating into any commercial environment. It can be used in broadcast and contractor installation markets, and records in WAV, MP3, SD/SDHC/SDXC, USB memory, and CD application formats. Built with parallel and RS-232C serial control, along with up to 20 tracks of flash start, the media recorder provides balanced and unbalanced I/O, and coaxial digital I/O. These unique features make the SS-CDR250N Two-Channel Networking CD and Media Recorder an ideal one rack-space media solution. - Balanced and unbalanced analog I/O (XLR and RCA jacks)
- Record or dub to CD-R media @ 44.1K/16-bit
- AES/EBU and S/PDIF digital I/O
- Optional IF-DA2 Dante card allows the unit to operate on a Dante audio network
- Sample rate converter on digital inputs
- RS-232C Serial and 25-pin parallel control ports
- Records to SD Card or USB media
- Automatic file close saves file every 2 seconds to prevent data loss if power is interrupted while recording
- Pre-record records the input buffer so that the start of a recording isn't missed
- Auto cue and auto ready for instant track playback
- Power-on play begins playback as soon as the unit is switched on
- Graphic LCD display with time, level, and menu information
- Security screw to keep the SD slots covered
- VSA (Variable Speed Audition) changes playback speed without changing the pitch and vice-versa
- Compact 1U rack-mountable format
- Ethernet connection can be used for control and file transfer
- Microphone inputs with phantom power
- Supports SDXC media for cards larger than 32 GB (up to 128 GB)
- Redundant recording feature records program to both cards simultaneously
- Relay record begins recording on the second card when the first one fills up
- Free app for iOS and Android allows the recorder to be operated from a smartphone
- FTP client and server functions allow recordings to be automatically uploaded to a server, or for program to be pushed to a player from a remote location
- Password protection and file encryption prevent stolen data assets
- Scheduled recording triggers recording or playback at a certain time each week, etc. Can be used together with automatic uploads for instant availability
- SNTP function allows the internal clock to be set using internet time servers
- Link playback function allows two units to be operated simultaneously for redundant backup
- Compressor and limiter on input
- Auto level control monitors and adjusts the input signal
- Power-on record function starts recording as soon as power is switched on
- Mono mix playback function
- Three user presets allow quick setting of input level, sample rate, etc.
- Auto-mark function shows where a file has clipped
- Dual-format recording simultaneously captures files as WAV and MP3 format
UPC: 043774032648 In the Box Tascam SS-CDR250N Two-Channel Networking CD and Media Recorder AC Power Cord Limited 1-Year Warranty for Parts Limited 90-Day Warranty for Labor Table of Contents
|
Upload User Manual
Have you got an user manual for the Tascam SS-CDR250N Two-Channel Networking CD and Media Recorder in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersTascam SS-CDR250N Specs | | | Frequency Response | 20 Hz - 20 kHz ±0.5 dB (JEITA) | | Signal to Noise Ratio | 95 dB or more (JEITA) | | Dynamic Range | 95 dB (JEITA) | | Distortion | 0.005% or less (JEITA) | | Channel Crosstalk | 95 dB (JEITA) | | | | Supported Media | SD (512 MB to 2 GB)
SDHC (4 GB to 32 GB)
SDXC (up to 128 GB) card
USB memory (512 MB to 64 GB)
CD-R, CD-R-DA, CD-RW, CD-RW-DA | | Recording Formats | WAV: Stereo/Mono, 44.1/48/96 kHz, 16/24-bit
MP3: Stereo/Mono, 44.1/48 kHz, 64 to 320 kbps
CD-DA: Stereo, 44.1 kHz | | Playback Formats | WAV: Stereo/Mono, 44.1/48/96 kHz, 16/24-bit
MP3: Stereo/Mono, 44.1/48 kHz, 64 to 320 kbps
CD-DA: Stereo, 44.1 kHz | | Number of Channels | 2 mono, 1 stereo | | | | Connector | Balanced:
3-pin XLR (1: GND, 2: HOT, 3: COLD) | | Standard Input Level | +4 dBu (1.23 Vrms) | | Maximum Input Level | +20 dBu (7.75 Vrms) | | Minimum Input Level | -10 dBu (0.25 Vrms) or more | | Input Impedance | 22 kOhms | | Connector | Unbalanced:
RCA pin jacks | | Standard Input Level | -10 dBV (0.316 Vrms) | | Maximum Input Level | +6 dBV (2.0 Vrms) | | Minimum Input Level | -24 dBV (0.06 Vrms) or more | | Input Impedance | 22 kOhms | | | | Connector | Balanced:
3-pin XLR (1: GND, 2: HOT, 3: COLD) | | Standard Output Level | +4 dBu (1.23 Vrms) | | Maximum Output Level | +20 dBu (7.75 Vrms) | | Output Impedance | 100 Ohms | | Connector | Unbalanced:
RCA pin jacks | | Standard Output Level | -10 dBV (0.316 Vrms) | | Maximum Output Level | +6 dBV (2.0 Vrms) | | Output Impedance | 200 Ohms | | | | Connector | 1/4" (6.3 mm) stereo jack | | Maximum Output | 45 mW + 45 mW (into 32 Ohms load, 0.1% distortion) | | | | Connector | 3-pin XLR and RCA jacks | | Formats | IEC60958-3 (S/PDIF), AES3-2003/IEC60958-4 (AES/EBU) | | Input Frequency | 32 Hz to 96 kHz | | | | Connectors | 3-pin XLR and RCA jacks | | Formats | IEC60958-3 (S/PDIF), AES3-2003/IEC60958-4 (AES/EBU) | | | | RS-232C | Connector: D-sub 9-pin | | Protocol | RS-232C | | Parallel | Connector: D-sub 25-pin | | Maximum Input Voltage | +5.5 V | | Minimum Input Voltage | High Level: +3.75 V | | Maximum Input Voltage | Low Level: +1.25 V | | Output Format | Open drain (withstand voltage 50 V, maximum 50 mA) | | Maximum Output Voltage | Low Level: 0.5 V | | Power | +5 V Power Maximum Current: 100 mA | | | | Connector | 1.8" (3.5 mm) TRS jack | | | | Connector | Sub-mini 2.5 mm TRS jack (for RC-20 and RC-3F) | | | | Connector | RJ-45 (100Base-TX) | | | | Connector | USB A-type 4-pin | | Protocol | USB 2.0 high-speed (480 Mbps) | | | | Voltage | 100 to 240 VAC, 50/60 Hz | | Power Consumption | 100 V: 20 W, 110 V to 240 V: 23 W | | Operating Temperature Range | 41 to 95°F (5 to 35°C) | | Dimensions (W x H x D) | 19.0 x 1.8 x 11.9" (482.6 x 44.5 x 301 mm) | | Weight | 6.4 lb (2.9 kg) | | | | Package Weight | 10.65 lb | | Box Dimensions (LxWxH) | 21.6 x 15.6 x 5.5" |
Rating80% users recommend this product to others. And what about you?
This product has already been rated by 77 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
Logitech MK850 Manual...
Swan Bread maker SWBBA7...
Expert intel sixcore i5-8400 4GHZ turbo...
Color LaserJet Pro MFP M281fdw...
call of duty world war II...
|
| Discussion |
Latest contributions to the discussion:
Query
Name: Geoff Dibblee
Carson zOrb Digital USB Microscope
when useing the zorb it will not cover the whole of a stamp back or front as i am useing it for perfins stamps and whati have recived in the box just covers half a letter please can you help me to find away to enlarg the whole stamp
...
Blown transformer
Name: Dik Schouten
Demeter VTDB-2 Single Channel Tube Direct
Dear Sirs,where can i buy a new transformer for my VTDB 2b? If possible een 230 volt primary site...Y.S. Dik Schouten
...
Battery charger light does not turn yellow or green when charging LP-E17
Name: DAVE
Canon LC-E17 Charger for LP-E17 Battery
I have a new Canon battery charger for EOS R10 Camera. It has lights that turn yellow and green when charging the Canon battery that came with the camera. But when I put in the BM battery LP-E17 no lights come on. I can tell the battery is charged when I put it in the camera, b...
Stiff center dial wheel
Name: Reynolds, Jane
Tasco 10x50 Essentials Porro Binocular
It is very hard for me to turn the center wheel with the ridges on it.
Could you please email me the user manual for the Tasco 10 x 50 mm zip focus? Thank you...
Redfield 2-7x33
Name: Mike
Redfield 2-7x33 Revolution Riflescope
Can the elevation and windage knobs be reset to zero?
Thanks!...
|
|
