|
User Manual for VISLINK PROceiver Portable Receiver Kit for HEROCast Click to enlarge the picture
Contents of the user manual for the VISLINK PROceiver Portable Receiver Kit for
- Product category: Wireless Transmission Systems VISLINK
- Brand: VISLINK
- Description and content of package
- Technical information and basic settings
- Frequently asked questions – FAQ
- Troubleshooting (does not switch on, does not respond, error message, what do I do if...)
- Authorized service for VISLINK Wireless Transmission Systems
|
User manual for the VISLINK PROceiver Portable Receiver Kit for contain basic instructions
that need to be followed during installation and operation.
Before starting your appliance, the user manual should be read through carefully.
Follow all the safety instructions and warnings, and be guided by the given recommendations.
User manual is an integral part of any VISLINK product,
and if it is sold or transferred, they should be handed over jointly with the product.
Following the instructions for use is an essential prerequisite for protecting
health and property during use, as well as recognition of liability on the part of the manufacturer
for possible defects should you make a warranty claim. Download an official VISLINK user manual in which you will find instructions on how to install, use, maintain and service your product.
And do not forget – unsuitable use of a VISLINK product will considerably shorten its lifespan!
|
Product description The PROceiver Portable Receiver Kit from VISLINK is a compact, single box diversity receiver compatible with GoPro HEROCast and HEROCast BacPac wireless transmitters. Designed for use in demanding RF environments, the receiver is ideal for extreme sports, live events, and other applications where size, weight, and broadcast quality performance are important. Being a diversity receiver, the PROceiver employs dual antennas and uses maximum ratio combining (MRC) to enhance demodulated performance and an increased operating range. It features ASI MPEG4/H.264 decoding and supports resolutions up to 1080i and 720p at 50/59.94 fps.
A range of video outputs are provided including HD-SDI, composite, component, and an HD to SD down-converted composite output for monitoring. There are also digital and analog audio outputs, a Genlock input, and an Ethernet port for control. Onboard control and monitoring is available via the built-in TFT display and front panel buttons. A USB/Ethernet remote cable is included along with two low-loss RF cables, audio breakout cable, AC/DC power supply with power cable, and a dual fanbeam bracket to fit BSW (British Standard Whitworth) 3/8" tripods. - Key Features
-
- Compact and lightweight diversity receiver
- Operates on 2.0 to 2.5 GHz frequency band
- Compatible with HEROCast and HEROCast BacPac
- Supports 1080i and 720p resolutions at 50/59.94 fps
- ASI MPEG/H.264 video decoding
- DVB-T COFDM modulation
- Control via front panel buttons and Ethernet port
- Built-in TFT screen for video monitoring
In the Box VISLINK PROceiver Portable Receiver Kit for HEROCast 2 x 3 dBi Fanbeam Antenna Dual Fanbeam Bracket for 3/8" BSW Tripod USB/Ethernet Remote Cable 2 x RF Cable Audio Breakout Cable PS15V AC/DC Power Supply AC Power Cable Table of Contents
|
Upload User Manual
Have you got an user manual for the VISLINK PROceiver Portable Receiver Kit for HEROCast in electronic form? Please send it to us and help us expand our library of instruction manuals.
Thank you, too, on behalf of other users.
To upload the product manual, we first need to check and make sure you are not a robot. After that, your "Submit Link" or "Upload File" will appear.
Technical parametersVISLINK 9015670 Specs | | | Frequency Band | 2.0 to 2.5 GHz | | Frequency Selection | 16 Pre-Set Channels, or Tuning in 1 MHz Steps | | Tuning Range | 400 MHz (Modulation-Dependent, Consult Factory) | | Demodulation | DVB-T 2k | | Demodulation Modes | QPSK, 16-QAM, 64-QAM
FEC: 1/2, 2/3, 3/4, 5/6, 7/8
Guard Interval: 1/32, 1/16, 1/8, 1/4 | | Bandwidth | 6, 7, 8 MHz | | Noise Figure | 3 dB Typical, 4 dB Max. | | Threshold | -92 dBm to BER 10E-5 (nom. QPSK) | | Data Rate | 4.98 to 31.7 Mb/s | | | | Decoding | MPEG4/H.264, 4:2:2, and 4:2:0 | | Video Outputs | 2 x HD-SDI (SMPTE-292M, 299M)
1 x Analog Composite YUV and Y/V Component
Composite Monitoring Output (HD to SD Down Conversion) | | ASI | 2 x DVI ASI | | Resolutions and Frame Rates | 1920 x 1080i 50/59.94 Hz
1280 x 720p 50/59.94 Hz | | Latency | 20 ms, Transmitter | | Genlock Input | Composite Video Black Burst or Tri-Level Sync
Timing Offset: ± 18,926 ns in 37 ns Steps | | Digital Audio Output | 2 x Stereo SDI Embedded or AES/EBU | | Analog Audio Output | 2 x LEMO-Type (2 x Mono or 1 x Stereo) | | | | Remote Control | Ethernet | | Software Upgrade | USB Port | | Power Supply | 10 to 32 VDC | | Operating Temperature | -4 to 122°F / -20 to 50°C | | Operating Humidity | 95% | | Operating Altitude | 2.8 miles / 4500 m | | Dimensions | 3.0 x 7.0 x 10.8" / 7.6 x 17.9 x 27.5 cm, Including Connectors | | Weight | 6.4 lb / 2.9 kg | | | | Package Weight | 21.4 lb | | Box Dimensions (LxWxH) | 24.0 x 20.0 x 17.0" |
Rating100% users recommend this product to others. And what about you?
This product has already been rated by 24 owners. Add your rating and experience with the product.
Discussion
Ask our technicians if you have a problem with your settings,
or if anything is unclear in the user manual you have downloaded.
You can make use of our moderated discussion.
The discussion is public and helps other users of our website who may be encountering similar problems.
The discussion is empty - enter the first post
Post a new topic / query / comment:
|
|
|
| Request for user manual |
You can’t find the operation manual you are looking for? Let us know and we will try to add the missing manual:
I’m looking for a manual / Request for manual
Current requests for instruction manuals:
TLR-4 Streamlight instruction manual for this item ThankYou...
NEWER F100 CAMERA MONITOR...
PhotoStage progessional...
powerpint...
Night Detective Quest 5M 5x Night Vision Monocular ...
|
| Discussion |
Latest contributions to the discussion:
TR-P5TP pink robot dog
Name: Allyson
Top Race Race & Remote Control
Hello we are having issues with the remote to the robot dog it just flashes a red light will not sync to the robot dog what so ever the dog is charged and batteries have been changed out more the once, Can i get help trouble shooting the issue or if something needs to be sent bac...
Query
Name: Libba Guyton
Canon Pixma TS9520 Wireless All-In-One Printer
Support Code 1851
Multi purpose tray guide is open. Close the guide and press OK.
Done and the same message continue to appear....
Manual
Name: Grant
Konus KonuStart-700B 60mm f 11.6 Refractor
Please send user manual for Konustart-700B to above email address....
Fs3x manual
Name: Randy Reid
DigiTech FS3X Three-Function Foot Switch
I need manual
...
adding additional chime
Name: Stan Stansfield
OhmKat Video Doorbell Power Supply for
The additional chime does not work and is closure to the transmitter then the first one. I plugged in the additional chime and set the volume and chime. The original chime works when the additional chime is plugged in to new location. The original chime is located further away bu...
|
|
