|
LEDLENSER Signal Cone for Tac Torch |
The orange Ledlenser Signal Cone fits on the front of the Tac Torch flashlight and is designed to diffuse and disperse light to be highly visible in multiple directions for crowd or traffic control in low-light and darkness. Compatible Flashlights Tac Torch UPC: 847706098067 In the Box LEDLENSER Signal Cone for Tac Torch Flashlight (Orange) ...
|
|
LEDLENSER H14R.2 Rechargeable Headlamp |
With a 1000-lumen maximum output and a rear-facing blinking red safety light, the Ledlenser H14R.2 Rechargeable Headlamp will make sure you can see and be seen during your after-dark activities. This rechargeable headlamp features four output settings – Power, Low Power, Boost, and Blink – and a dimmer, so you can set the lamp to exact...
|
|
Greenlee Pocket Probe Pick |
The Paladin Tools Pocket Probe/Pick is for pulling wire, slicing, stripping cables and cleaning debris off terminal panels. It is small, lightweight, and pen-sized with a clip for carrying in a pocket. Probe pick for pulling wire, slicing, stripping cable and cleaning debris off terminal panels Small and lightweight, pen-sized with clip for ...
|
|
Maglite Mag Charger LED Rechargeable Flashlight |
The Mag Charger LED Rechargeable Flashlight from Maglite is a rugged, high-intensity LED illumination tool, featuring an anodized casing that is impact resistant to a drop of 3.3' and resistant to water and extreme temperatures. It has a spot-to-flood beam quick-focus system that requires less than a 1/4 turn of the head. Powered by a rechargeable...
|
|
Eclipse Tools 10" Forged Cable Cutter |
Ideal for cutting aluminum and copper cables, the 10" Forged Cable Cutter from Eclipse Tools features S45C steel blades, high leverage jaw, and PVC covered handle. The cutter has shear-cutting blades that leave round edges on the cable without flattening them. For Cutting 16mm2 Solid 4 AWG copper cables35mm2 Stranded 2 AWG copper cables70mm2 Fl...
|
|
LEDLENSER F1 LED Flashlight |
The black F1 LED Flashlight from Ledlenser is less than four inches long, delivers a maximum of 400 lumens, and operates on one lithium CR-123 battery. A click-type tailcap push button enables you to select one of four lighting modes: normal, low, strobe, and momentary; and since the switch is recessed, it can be propped up on its tail without fal...
|
|
Greenlee 701K-G Standard Tone and Probe |
The 701K-G is a kit comprised of a Greenlee 200EP Tone Probe Amplifier, a 7HP-G High Power Tone Generator, and a rugged nylon carrying case. The amplifier and tone-generator are intended to facilitate the testing and tracing of wire and cables. The probe, which can operate at levels of 30 dB, features a 3.5mm headset jack for monitoring tone in h...
|
|
Eclipse Tools 31-Piece Screwdriver with Bit |
With the 31-Piece Screwdriver with Bit Pack from Eclipse Tools you can take advantage of a wide variety of screwdriver bits including PH0, PH1, PH2, PH3, PZ0, PZ1, PZ2, PZ3; SL3.5, 4.5, 5.5, 6, 8; HX2, 2.5, 3, 4, 5, 6, 8; T5, T6, T7, T8, T10, T15, T20, and T35 sizes. The bits can be stored in the compact magnetic bit storage case for safe keeping,...
|
|
LEDLENSER USB Charging Cord for H7R |
The Ledlenser USB Charging Cord is a replacement cable for the H7R flashlight. It allows you to charge the light from any USB power source. UPC: 847706019802 In the Box LEDLENSER USB Charging Cord for H7R Flashlight Limited 5-Year Warranty Table of Contents ...
|
|
LEDLENSER P7.2 Flashlight |
The P7.2 Flashlight from Ledlenser is a dual output device. It delivers 320 lumens of light for a maximum of one hour, and 40 lumens for a maximum of 25 hours. This flashlight is equipped with the Advanced Focus System which combines a reflector and a lens. It produces an evenly illuminated beam spot during entire focusing range. Use the tailcap p...
|
|
